Programming instructions
Operation
Auto Scan Envelope information
The envelope information of all messages can be played without listening to the messages themselves.
While the envelope information is playing any of the playback commands can be used. The envelope
information can be interrupted and the message played, saved, replied to, etc. After the interruption,
the system then continues playing envelope information for the remaining messages.
cl
1 Play message
cl
3
Erase
n - PI F[ - ~~~&~~
- B Reply - K$z$ages
- q
Send a COPY
c1
o Return to
normal mode cl
2
Save
Play previous message
During message review, a subscriber may backup and play the previous message.
cl
1 Play message
D
3
Erase
Listen to
the messages
Listen t0 preViOUS --c 6 Send a copy
cl -a
4 Reply
cl
,, Return to
normal mode
D
2
Save
6.5.7 AFTER LISTENING TO A MESSAGE
Replaying a Message
At the end of a message (when the system prompts with the “After Listening” menu) a subscriber
can
replay that message in its entirety.
cl
1
- End of message - 1
0
- Message replays
Save
If the message needs to be acted on later, it may be saved. Saved messages are kept in a separate
queue. They will be played after new messages. The procedures for returning a message to storage
and for storing a new message are the same.
cl
1
- End of message - 2
cl
- Message is saved
Erase
If the message does not require action, it should be erased. Erasing messages keeps the mailbox clear
and reduces the need for additional system storage capacity.
# Confirm erase - Message is erased
0
1
- End of message - B - { :
* Cancel
-NOTE: Once a message has been erased, it cannot be retrieved.
INFOSTARIVX2
System
Administrator’s
Manual
6.7