Programming instructions

Section 3 - Mailboxes
3.1 INTRODUeTION
There are two programming screens the system administrator uses to add, modify, or delete mail-
boxes. There is a Mailbox Set-up screen which is used to program the mailbox, and associate the
mailbox with an extension number in the telephone system. The Class of Service programming screen
is used to program various features and system resources for groups of mailboxes rather than having to
program each mailbox individually.
NOTE: A Class of Service must be created before it is used on the Mailbox screen.
3.2 CLASS OF SERVICE
The INFOSTAWVX2 allows you to establish multiple classes of service through which you grant or
restrict access to various features and system resources. As system administrator you may specify dif-
ferent classes of service and then assign each mailbox to one of these classes. The system has two
default classes of service. COS 100 is used for general subscriber mailboxes. COS 700 is used to de-
fine the system administrator’s mailboxes. Provided below are the various features controlled by the
classes of service:
[CLASS OF SERVICE SCREEN]
CLASS OF SERVICE [-I NAME:
A) MAXIMUM NUMBER OF MESSAGES......................0 0
B) MAXIMUM MESSAGE LENGTH.........................12 0
C) MAXIMUM SILENCE DURING RECORDING .............. ...4
D) MINIMUM MESSAGE LENGTH ......................... ..O
E) GREETING MAXIMUM LENGTH.........................6 0
F) SPECIFIED DELIVERY TIME UP TO...................6 0
G) MAXIMUM SPECIFIED DELIVERY TIME MESSAGES........2 0
H) REVIEW METHOD FIFO/LIFO
........................
..l
I) GUESTS 1-9 ....................................
...4
J) KEEP NEW MESSAGES...............................3 0
K) KEEP SAVED MESSAGES.............................1 0
L) PERSONAL GROUPS.................................1 8
M) DESTINATION.....................................2 5
N) OK TO SEND MESSAGE TO SYSTEM GROUP LIST ........ ..Y
0) NOTIFICATION OF AUTOMATIC MESSAGE ERASE
........ ..Y
P) AUTOMATIC ALERT OF MESSAGE ERASE IN ADVANCE .... ..O
Q) NOTIFICATION OF NON RECEIPT OF MESSAGE AFTER
... ..l
R) END OF RECORDING ALERT IN ADVANCE...............1 0
S) TYPE OF OUT DIALING
............................
..O
SECONDS
SECONDS
SECONDS
SECONDS
DAYS IN ADVANC
lFIF0 2LIF0
DAYS
DAYS
Y/N
DAYS
DAYS
SECONDS
T) SEND MSG TAG (1:CONF 2:PRE 3:PROOF 4:SDT) IN..1234 [--
--I OUT i-1
U) MWI RESET OPTION.................................1
I-1
: [F3]Clear [FS]Save [F6]Del [F?]Scroll [FB]Find [FQ]Prev [FlO]Next [Esc]Quit
Figure 3-l Class Of Service Programming Screen
CLASS OF SERVICE
This is the class of service the information on the screen is for. The COS is a three digit number
which can range from 001 to 999. To avoid confusion, program the smallest number of classes of ser-
vice necessary for your installation.
INFOSTARIKX2
System
Administrator’s
Manual
3.1