Programming instructions

Initial Setup
2.12 INTEGRATING THE VX2 AND A TELEPHONE SYSTEM
If the telephone system you are connecting the VX2 system to is not listed on the Auto Integration
(PBX Selection) screen, but does support integration, select EXC on the Auto Integration screen.
Then perform the following:
0 Create a 3-character code to designate the telephone system.
@ Create and save a PBX Parameter and PBX Function screen using the created 3-character code.
0 Change the Link to PBX field on the Line Set-up screen (Run field = EXC) for each of the ports
in the system to the selected 3-character code.
2.13 SUPPORTING INTEGRATION
A telephone system supports integration to the VX2 if the following qualifications are met:
l Using a dial code, the telephone system can be told to turn on and turn off a message waiting
indicator on a telephone.
0 The telephone system can forward calls from a station to the VX2 system and transmit a station
identifier code when the call is answered by the VX2 system.
2.14 MAILBOXES
Before starting the system, you may wish to enter classes of service and mailbox numbers. Refer to
the Mailboxes chapter for this information.
2.15 STARTING THE SYSTEM
Once programming is completed, the system must be started again to begin processing calls. From the
Main Menu,
1.
2.
3.
4.
5.
6.
7.
Press F3 to reach the Dialogue menu.
Press 1. The Run Dialogue screen appears with the cursor in the upper left comer. The installed ports
appear on the screen.
Press F5. The system prompts for confirmation.
Press FlO or F9 to select the correct Run screen.
Press Y. The system prompts to start running.
Press RETURN. The system is now running and ready to process calls.
If you wish, press the F6 key to hide the Run Dialogue menu. Press F7 to display the screen after it has
been hidden.
INFOSTARIVXZ
System Administrator’s Manual
revised 7191
2.15