Programming instructions
Initial Setup
NOTE: In software versions prior to release 2.0, if a change is made to a PBX Function
screen, and the’change is saved, the corresponding PBX Parameter screen must also be
saved (even if no changes were made to this screen).
2.10.1 MESSAGE WAITING INDICATION
The dial codes the telephone system uses to turn on and off the message waiting indication are pro-
grammed on this screen. This information is programmed
in DTMF Set On
and
DTMF Set
Off
fields
for function MWI.
Certain PBXs permit multiple message waiting indication codes to be dialed while a port is off-hook.
Other PBXs require a port to go off-hook and on-hook for each message waiting indication code.
The first Flags
field is used to tell the system how to dial the message waiting indication dial codes
when there is more than one indication waiting to be dialed. If the field is left blank, the MWl
port(s) goes off-hook and dials the MWl codes one after the other and then goes on-hook. If a 1 is
entered in this field, the system goes off-hook, dials one MWl code, and goes on-hook. This process
is repeated until all MWl codes have been dialed. Consult the
Integration Note
for the particular PBX
to determine the proper setting of the first
Flags
field.
The system ports used to send the message waiting indication may be programmed in
the Use Port
field.
From the
Main Menu,
press the F4 key, then press
3. The PBX Functions
screen appears. See Figure
2-9.
The
ESCAPE
key can be used at any time while in this screen to return to the
Main Menu.
At the top of the screen in the left comer is a place to enter the system code. This is a 3-character
code used to define which telephone system the VX2 system is being integrated with. This code must
be the same code used on
the Line Set-up
screen and the
PBX Parameters
screen
(System code
and
PBX code
are the same thing).
1. Enter the 3-character system (PBX) code. For example, IDS for the EXECUTONE IDS. The cursor
moves to
Function.
2. Enter
MWI.
The system prompts for confirmation. Press Y. The present
PBX Functions
programming
is displayed.
3. Enter the dial codes for
DTMF Set On
or Off for the particular telephone system.
4. Press the down arrow key until the cursor reaches Use
Port.
5. Enter the port number(s) which are to be used for turn on and off the message waiting indicator. Press
the RETURN
key after each entry. If no ports are entered, the system uses all ports for MWI.
6. Press the
F5
key. The system prompts for confirmation. Press Y if all information is correct. Press N to
cancel the request to save the information.
7.
Press the
ESCAPE
key to return to the
Main Menu.
2.10.2 OUTDIAL
The
PBX Functions
screen is used to designate which ports are to be used to place outdial calls.
From
the Main, Menu,
press
the F4
key, then press
3. The PBX Functions
screen appears. See Figure
2-9.
The
ESCAPE
key can be used at any time while in this screen to return to
the Main Menu.
At the-top of the screen in the left corner is a place to enter the system code. This is a 3-character
code used to define which telephone system the VX2 system is being integrated with. This code must
INFOSTARIVXZ
System Administrator’s Manual
revised 7191
2.13