Programming instructions
Initial Setup
next field. To move to the next field before a field is filled, press the
RETURN
key. Use the
DELETE
key to remove information from a field. Use the
Fl
key to clear the field and start over.
7. To erase the entire screen and start over, press the F3 key.
8. Once all information for this screen has been entered, press the
F5
key to save the information. The
system prompts for confirmation. Press Y if all information is correct. Press N to cancel the request to
save the information.
9.
Press the
ESCAPE
key to return to
the Main Menu.
[PBX PARAMETERS SCREEN]
SYSTEM CODE ) IDS
DIAL-
USE TONE OR PULSE..............T
[Tl
T-P
TRANSFER SEQUENCE..............&, [&,#
OUTBOUND CALLS PREFIX..........&, [Q, -
] PBX AREA CODE [
1
1
INTERNAL CALLS PREFIX..........&, [,
1
RECONNECT......................&
[&a *-I
BEFORE DIALING/RECEIVING
MINIMUM ON-HOOK DURATION (SEC).1 [03]
WAIT FOR DIAL TONE (SEC)......2 [02]
PAUSE....., [,-I
WINK @SEC) [-I
HANG-UP-
SILENCE ON DURATION............0 [000]
SILENCE OFF DURATION...........0
# OF REPETITION TO CHECK.......0 :::;I
MAX NON SILENCE PERIOD (SEC)...0 [08] (RECORD)
MAX NON SILENCE PERIOD (SEC)...0
[lo] (PLAYBACK)
COMMUNICATION-
PORT NUMBER....1 [l] BAUD RATE..00000 [00000]
STOP BIT.......1 [l] PARITY.........0 [0]
DATA WORD......8 [S]
X-ON..........30 [30] X-OFF.........70 [70]
BUFFER IN. ..1024 [1024] BUFFER OUT..1024 [1024]
[FB]Clear [FJ]Save [FG]Del (F7]Scroll [FB]Find [FQ]Prev [FlO]Next [Esc]Quit
Figure 2-8 PBX Parameters Screen
MODIFYING PBX PARAMETER SCREEN
From the
Main Menu,
press the F4 key, then press 2. The programming screen appears. See Figure
2-8. The cursor should be in the
System Code.
If this is not the record to be modified, press F3, and
then Y to clear the screen.
NOTE: The
F9
and
FIO
keys can be
used
to scroll back and forth through the records
instead of entering the company, mailbox, etc. to find a record.
1. Enter the desired system code. The system should display the message, “Information found, display
it? ”
2. Press the Y key.
3.
Use the
RETURN
key to move the cursor to the field to be modified, and enter your changes. Use the
Fl
key to clear the field.
4. When all desired fields are changed, press the F5 key. The system prompts for confirmation. Press Y
to save the information, or N to return to the screen and change something.
5. To clear the screen, press the F3 key, and answer Y.
INFOSTARIVXZ
System Administrator’s Manual
revised 7191
2.11