Vodavi Infostar VX2 : Programming instructions : Page 27

InitiaZ Setup

Minimum On-hook Duration

Wait For Dial Tone

PBX Area Code

Pause

Wink

HANG-UP AREA

Silence On Duration

Silence Off Duration

# Of Repetition To Check

Max Non Sit. Prd Record

Max Non Sil. Prd Playback

This is the minimum time a VX2 system port must stay on-hook after

completing a call before going off-hook for another action. This field

is used to prevent calls from being inadvertently placed on hold. This

field defaults to 1 second.

This is how long the VX2 system waits for dial tone from the tele-

phone system before going on-hook and trying again. This field de-

faults to 2 seconds.

This is the S-digit telephone area code of the location of the system.

This is the length of a system pause. Each comma represents 2 sec-

onds.

This field is not used and should not be programmed.

This is how long the system listens to dial tone while recording before

disconnecting from the call. This field defaults to 0, but should be

programmed for 8 seconds. This field should be programmed to a val-

ue within seconds of the Max Non Silence Playback value and should

be less than that value.

This is how long the system plays dial tone (within a message) during

a playback before disconnecting from the call. This field defaults to 0,

but should be programmed for 10 seconds. This field should be pro-

grammed to a value within seconds of the Max Non Silence Record

value and should be greater than that value.

COMMUNICATIONS AREA

There are no fields used in this area at this time. This area should not be changed from its default

programming.

2.9.1 HOW TO PROGRAM

ADDING PBX PARAMETER SCREEN

From the Main Menu, press the F4 key, then press 2. If there is an existing screen, it is displayed.

Press F3, and then Y to clear the screen. If there are no existing screens, the screen is blank. The

ESCAPE key can be used at any time while in this screen to return to the Main Menu.

At the top of the screen in the left comer is a place to enter the system code. This is the 3-character

code assigned to a particular telephone system. This code corresponds to the to the entry in the Link

To PBX field of the Line Set-up screen. This tells the system which set of PBX parameters to use for

a given telephone interface port.

1. Enter the system code.The system should display the message,

“Information not found, press RE-

TURN to continue.” If the system displays the bin number, or displays “Information found, display it

Y/N?” the system code has already been programmed, select another.

6. Press the RETURN key. Change the information on the screen as necessary for the installation. Use

the RETURN and arrow keys to move around the screen. As a field is filled, the cursor moves to the

2.10

INFOSTARIVX2

System Administrator’s Manual

revised 7191