Programming instructions

Initial Setup
In addition to defining the task for each of the system's ports, the Run Dialogue screen is used to
link a port to a particular Line Set-up screen. The Run field at the top left of the screen defines
which Line Set-up screen is used for a particular port. The Line Set-up screen defines the set of PBX
values used on a port (see the Line Set-up Screen section).
The Run Dialogue screen also displays the amount of space left on the hard disk in a bar graph on
the left side of the screen. The top of the graph shows HD: 1 (the hard drive). The bottom of the bar
graph displays the total storage (in hours) of the drive.
Along the bottom of the screen, the system displays the current time and date programmed in the
system. A cursor moving from left to right indicates the system is running.
InfoStar Vx2
Figure 2-3 Run Dialogue Screen
2.6 TAKING THE SYSTEM OFF-LINE
The system is taken off-line by pressing F4 then F7 and then the ESCAPE key. When the ESCAPE
key is pressed, message processing stops. The system prompts for confirmation to stop running. Press
Y. The Run Dialogue screen clears. From here, press the ESCAPE key to reach the Main Menu (Fig-
ure 2-l).
NOTE: All programming instructions in this manual presume the system is off-line unless
otherwise noted. The system may be programmed while on-line, however, the screens may
operate differently than the instructions for off-line programming indicate. For example,
steps requiring confirmation may be simplified. This is intentional and is designed to speed
the on-line programming.
NOTE: Programming instructions in this manual refer to the RETURN key. This key may
-be labeled RETURN, ENTER, or just u depending upon the keyboard.
2.4 INFOSTARIVX2
System
Administrator’s
Manual