Programming instructions

System- Ad.min,istrato.& M:an.u.al~: S-u pp&vmt-
“” ..i
:
..:
The lNFOSTAR’“W2 is now being shipped with softwareversion 3.0. This document gives a description ofthe
new features and the changes that were made to the existing features. A new section - Section 70 - System
Administration Reports has been added to the back of this manual. The command summaries on page 5.7 and
pages 6.25 -26 have been updated to software version 3.0.
New Features
D Access Code Protection For The System Administrator - The On Line Programming Menu is now pro-
tected by an access code. After pressing F8 for the On Line Programming Menu, the system prompts for an
access code. See Figure 1. The access code is the 3-character company code and the access code forthe
system administrator’s mailbox. For example, if the company code is EXC and the system administrator’s
mailbox access code is 6947, the access code is entered as EXC6947.
[ver 3.01
COMPANIES
[A] Setup
[ON LINE PROGRAMMING MENU]
[D] Status
[E] Link
[F] Ext. Access Code
[cl Type
[H] Out Dial Sched.
[I] C.C.R
IJ1 Class Of Service
[PgDn] Next [Esc]Quit
[S] Line Set Up
[T] Bin Numbers
[U] D.N.1.S Table
[V] Message Info
InfoStar Vx2
Figure 1
12/16/91 17:23
0 New Sizes - The following new configurations of the INFOSTAWX2 are available:
o Ports - The VX2 can be ordered in the following additional port increments: 12, 16, 20, and 24.
l Hours - The VX2 can be ordered in the following additional disk sizes: 30, 60, and 100 hours. The 30
hour disk drive can be ordered with either the INFOSTAR/AP/G or the INFOSTAR/AP/12. However, both
the 60 and 100 hour disk drives require the use of the INFOSTAR/AP/12.
March 2, 1992
Page 1 of 4