Programming instructions

System Administration Reports
10.4.2 SYSTEM ADMINISTRATION REPORTS
1. After selecting a report to print, press the designated letter. For example, to print the Mailbox Direc-
tory report, press L.
2. Some of the reports (M, Q, R, S, & T) prompt for a start and end date. Press the Enter key if the start
and end dates listed are the ones you desire, or enter the start and end dates as 2-digit month, day,
and year, and then press the Enter key. For example, enter 021392-021792.
Enter Start Date-End Date (MMDDYY-MMDDYY) ), [021792-0X792]
3. When the system has finished processing the report, the screen displays, “Report complete.” Press any
key to continue. The report screen appears.
f
File s~~c[\RPT\REP~RT.DsP
] Opra]P:Print C:Com F:File Page[-]
4. The cursor will highlight the [Opr] bracket. Press the P key, for print.
5. The screen displays:
File S~~~[\RPT\REPORT.DSP
] Opr[l]P:Print C:Com F:File Page[-]
Working . . .
Press [Esc] To Abort
Set The Printer . . .
Ready To Print..? (y/n)
6. Make certain the printer is on-line, has paper, and the top of form is where you wish.
7. Press the Y key. The system displays:
“Working” which will flash across the screen, and the report will
begin to print. If you press N (No), the system displays,
“Ok” and the cursor moves to the [Page]
bracket. To display the report, press the LEFT arrow key and press S. To leave the report and return
to the On Line Programming screen, press the Esc key.
8. While the report is printing, you can press the Esc key to abort the printing process.
NOTE: A local printer is attached to the parallel printer port of the VX2. For additional
information, refer to the Installation section of the INFOSTARWX2 Technical Manual.
10.6
INFOSTARIKX2
System Administrator’s Manual
revised 2192 - sqftware version 3