Programming instructions

Custom Call Routing
13. Display CCR 0000001 Msg# 3 on the screen. Record a greeting similar to the following, then pressm.
“New Car Sales: For information on Chrysler cars, press one. For Ford cars, press two.
For GM cars, press three.”
14. Display CCR 0000001 Msg# 4 on the screen. Record a greeting similar to the following, then press a.
“Parts Department. For information on the price of a part or availability, press one. To
check on an order previously, placed press two.”
At this point the system is programmed for CCR operation. The last task to be accomplished is to
program the system ports to route calls to Custom Call Routing rather than normal voice mail. This is
accomplished on the Run Dialogue screen.
8.9.9 PROGRAM RUN DIALOGUE SCREEN
Program the Run Dialogue with the starting point for this example (T CCRBX 0001):
1.
2.
3.
4.
5.
Take the system off line (press F4, F7, and then ESCAPE). The system prompts “START SHUT-
DOWN PROCESS (Y/N)?”
Press the Y key. The system displays the Run Dialogue screen.
Using the RETURN key to move the cursor, enter T CCRBX 0001 to route calls to CCR Mailbox 1
message 1. The Fl key may be used to clear a field.
Enter the new starting point for each of the system ports.
When all the ports have been programmed, save the information by pressing F5 and then Y. Press the
RETURN key, to place the system on line.
i-1 1
23 t --i
[-I[
24 t -3
02/04/91 12:29
8.25
Figure 8-9 Run Dialogue Screen Programmed For CCR
INFOSTARIKX2
System Administrator’s Manual
revised 7191