User`s manual

Safety information
33
32
Safety information
• DO NOT use this product near water, for example in a damp basement or close to a swimming pool.
• DO NOT expose the device to moisture, dust or corrosive liquids.
• DO NOT place objects on the device.
• DO NOT install, use or maintain the device during a storm. There is slight risk of electrocution.
• Connect ONLY approved components to the device.
• DO NOT open the device or unit. If you open or remove the covers, you may be exposed to dangerously high
voltages or other hazards. ONLY specialized and knowledgeable technicians should service or disassemble the
device. Contact your supplier for more information.
• Make sure that you have inserted cables into the correct ports.
• Place the connection cables carefully to eliminate any possibility of somebody stepping or stumbling on them.
• Make sure that you have disconnected all cables from the device before you take it for servicing or disassemble it.
• Use ONLY an appropriate power adapter or cable for your device.
• Connect the power adapter or cable to an appropriate power supply line (e.g. 110V AC in Northern America or
230V AC in Europe).
• DO NOT let anything come into contact with the power adapter or cable and DO NOT place the product in a place
where somebody could step or stumble on it.
• DO NOT use the device if the power adapter or cable is damaged. There is a risk of electrocution.
• If the power adapter or cable is damaged, disconnect it from the power socket.
• DO NOT try to repair the power adapter or cable. Contact your nearest supplier and buy a new one.
• DO NOT use the device outdoors and make sure that all connections are located indoors. There is slight risk of
electrocution.
• DO NOT block the device ventilation openings. Insufficient air flow may damage the device.
• Use only a telecommunications cable no. 26 AWG (American Wire Gauge) or a cable of a higher cross section.
• Aerial warning! This device complies with the ETSI and FCC certification requirements when used with the
accompanying aerial(s). Use only the accompanying aerial(s).
• If you mount the device on the wall, make sure not to cause any damage to power, gas or water lines.
• DO NOT expose the battery to excessive heat or a naked flame.
• DO NOT immerse the battery in water.
• DO NOT subject the battery to strong blows or let it come in contact with water droplets.
• DO NOT disassemble or modify the battery for any reason whatsoever.
• DO NOT keep the battery discharged.
• Charge the battery at temperatures ranging between 0°C and +45°C.
• DO NOT store the battery with less than 50% of its original capacity or at a temperature other than specified.
Appropriate disposal of the product
(Electric & electronic equipment waste)
The signs affixed on the product or its accompanying manuals indicate that it should not be disposed of with
other domestic waste when its life cycle is over. To help prevent possible health or environmental hazards
(due to uncontrolled waste disposal), and assist the sustainable reuse of material resources, please, separate
it from other types of waste and recycle it. Domestic users should either contact the shop where they bought
the product or local services to find out where and how they can deliver the product for environmentally safe
disposal. Corporate users should contact their suppliers and check the terms and conditions laid down in
their purchasing contracts. This product should not be mixed with normal waste.
2. Declaration of conformity
Vodafone-Panafon Hellenic Telecommunications Company hereby states that this Vodafone DSL Router complies with
the essential requirements and other relevant provisions of Directive 1999/5/EU.
It also complies with the standards established by the following:
EN300328V1.6.1 (2004-07), ΕΝ301 489-01 V1.4.1 (2002-08), ΕΝ301 489-17 V1.2.1 (2002-08), Safety ΕΝ 60950-
1:2001. In accordance with the provisions of Directives 89/336/EEC, 92/31/EEC, 93/68/EEC, 99/5/EEC and LVD
73/23/EEC. FCC approved
Declaration of Interference in accordance with the requirements of the Federal Communications Commission (FCC)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must withstand any interference received, including interference that could cause undesired operations.
CE: RE980106H01
SAR: RM980106H01
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Section
15 of the FCC regulations. These limits are designed to provide reasonable protection from harmful interference in
residential installations. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the distance between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit other than that to which the receiver is connected.
4. Consult the retailer or an experienced radio/TV technician for assistance.
Radiation exposure statement in accordance with FCC requirements
• This transmitter must not be located or operate in conjunction with any other antenna or transmitter.
• The IEEE 802.11 b or 802.11 g function of this product in the USA is restricted by the firmware to channels 1 to 11.
• Compliance to FCC requirements on exposure to radiofrequencies, demands that there must be a minimum 20 cm
distance between the device antenna and any persons near it.