User guide

7
Getting Started
SoftBank 203Z
Display
Display
Item Description
Icons
Communication, battery, and message
statuses
Status
notifications
Text messages regarding communication
and malfunction
Data
transfer
volume
Data communication volume for Data
traffic/Maximum traffic, and Data traffic
regarding Maximum traffic via bar display
(bar becomes red when Maximum traffic is
exceeded)
Icons
Icon Description
Mobile network reception level
Out of service area
Connected Internet Wi-Fi/Internet Wi-Fi
reception level
Internet Wi-Fi disabled
Appears when roaming
Battery full
Battery low
No battery (charging required)
, or
Connected Network
Connected to Internet Wi-Fi
Connected to Internet
Unconnected to Internet
Connected WLAN devices
WLAN disabled
Software update available
There is a message
Can supply power
Cannot supply power
Status Notifications
Wi-Fi router gives information on communications and
malfunction statuses via texts.
Notification Description
DATA MAIN SoftBank 4G or ULTRA SPEED area
DATA SUB ULTRA SPEED sub area
No Service
Signal detected, but service unavailable
(Immediately after moving into the service
area from outside the service area, etc.)
Out of Service No signal
Insert USIM USIM Card not installed
Invalid USIM Invalid USIM Card installed
Enter PIN
PIN entry required (PIN entry is required
on WEB UI)
Enter PUK
PUK entry required (PUK is required on
WEB UI)
USIM Busy Reading from/writing to USIM Card
USIM Lock USIM Card completely locked
PUK Lock
USIM Card is permanently locked because
PUK entry was incorrect ten times in a
row (USIM Card needs to be changed
(paid))
Turning off Display/Sleep Mode
・If Wi-Fi router is not used for 1 minute, Display turns off
automatically. Press INFO key to illuminate Display.
・If not using or charging Wi-Fi router for a while with
no connected WLAN devices, Wi-Fi router enters Sleep
mode after Display has turned off to save power. (Sleep
activation timer is set to 1 minute by default.)
・After Wi-Fi router enters Sleep mode, WLAN becomes
disabled.
・Pressing INFO key will turn on Display and cancel Sleep
mode. After Sleep mode is canceled, WLAN becomes enabled
and Wi-Fi router will be able to connect to WLAN devices.
・Some WLAN devices can disconnect the WLAN connection
if there has been no data communication for a while. If
disconnected by such a device, Wi-Fi router enters Sleep
mode.
・Change the setting for sleep activation timer on Web UI. See
"Sleep Timer Setting (Sleep Mode)."