User manual

19
CE approval
(European
Union)
This device has been tested to and conforms to the regulatory requirements of the European
Union and attained CE Marking. The CE Mark is a conformity marking consisting of the letters
“CE.” The CE Mark applies to the products regulated by the central European health, safety
and environmental protection legislation. The CE Mark is obligatory for products it applies
to:themanufacturerafxesthemarkinginordertobeallowedtoselltheirproductinthe
European market.
The wireless device is approved to be used in the member states of the EU. NetComm Wireless
declares that the wireless device is in compliance with the essential requirements and other
relevant provisions of the Radio and Telecommunications Terminal Equipment Directive
1999/5/EC (R&TTE Directive). Compliance with this directive implies conformity to the
following European Norms – N 60950 – Product Safety, EN 301 489 EMC, EN301511 GSM RF,
EN301908UMTSRF,EN62311SARTechnicalrequirementforradioequipment.Anotied
body has determined that this device has properly demonstrated that the requirements of the
directivehavebeenmetandhasissuedafavourablecerticateofexpertopinion.Assuchthe
devicewillbearthenotiedbodynumber0682aftertheCEmark.
The CE Marking is not a quality mark. Foremost, it refers to the safety rather than to the quality
of the product. Secondly, CE Marking is mandatory for the product it applies to whereas most
quality markings are voluntary.
Marking:TheproductshallbeartheCEmark,thenotiedbodynumber(s)asdepictedtothe
left. CE0682.
Thisproducthasalsopassedthefollowingcerticationstandards–
CE SAR- EN62311/EN62209-2
CE RF – EN301511, EN301908-1/-2,
CE EMC – EN301489-1/-7/-24, EN55022/EN55024
CE Safety – EN60950
NOTE: It is highly recommended that the device must be kept at least 20cm away from the
human body.
This is a regulatory requirement and applies to all 3G capable devices meeting standard
regulatory compliance such as the compliance standards listed above.
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Vodafone MachineLink 3G
IMEI:
ICCID:
MAC:
S/N:
FCC ID: XIA-NWL10
IC: 8847A-NWL10
Model: NWL-10
Part Code: NWL-10-01
Power: 8-35VDC <6W
or 802.3af PoE
Designed in Australia.
Made in China
0682