Owner`s manual

Setting up the Speaker Stand

Setup each SS-88 speaker stand by extending the support lefts to a

position that is stable and tighten the tension mechanism ﬁ rmly. Each

end of the SS-88 pole has a particular diameter ﬁ tted for common

speakers’ mounting cavities. If the SS-88 pole does NOT ﬁ t ﬂ ush into the

mounting adapter on the PV-1800, loosen the SS-88 pole and reverse it

in the stand and then remount the speaker.

Mounting the Speaker(s)

Once the adapter is securely attached to the speaker:

1. Place the PV-1800 on the SS-88 speaker pole

2. Fasten the fastener on the adapter until it is secured tightly

3. Repeat this for the next speaker

Voltage Selector

The PV-1800 has a voltage selector on the rear panel that switches

between two voltage settings:

115V - North America, Canada, some South America

220V - Europe, Asia, some South America

Note:

The PV-1800 comes preset to 115V and will only need to be

Note: The PV-1800 comes preset to 115V and will only need to be Note:

switched if it is being used in a region that requires 220V.

Switching the Voltage

1. Switch the selector to the proper voltage

CAUTION:

Using the speakers while set to the wrong voltage can result in permanent damage and will void the

CAUTION: Using the speakers while set to the wrong voltage can result in permanent damage and will void the CAUTION:

warranty. Make sure you have set the PV-1800 to the correct voltage before using.

Setting Up