Owner`s manual

14
Adjusting the Microphone V
olume
Adjusting the Microphone VolumeAdjusting the Microphone V
Use the MIC LEVE
L control to adjust the
microphone volume
1. Turn the MIC LEVEL control clockwise towards MAX to raise the level
2. Turn the MIC LEVEL control counter-clockwise towards MIN to lower the level
Adjusting the Line In Level
Use the LINE IN L
EVEL
co
nt
rol to adjust
th
e level fo
r the player or mixer that is
connected to
the RCA or XLR LINE IN channel.
1. Turn the LINE IN LEVEL control clockwise towards MAX to raise the level
2. Turn the LINE IN LEVEL control counter-clockwise towards MIN to lower the level
Adjust
ing the Echo Level
You can adjust how much of the echo effect is p
resent in the microphone signal
1. Turn the ECHO control clockwise towards 10 to raise the amount of echo
2. Turn the ECHO control counter-clockwise towards 0 to lower the amount of echo
Adjusting the Mas
ter
Volume
You can adjust the master volume using the MASTER control
1. Turn the MASTER control clockwise towards MAX to raise the volume
2. Turn the MASTER control counter-clockwise towards MIN to lower the volume
NOTE:
If the MASTER volume is turned up high but no microphone and/or music can
be heard, make sure the MIC LEVEL and/or LINE IN LEVEL controls are turned up
high enough.
Adjusting the
Treble Tone
The
treble control adjust
s how much treble or high-frequency is applied
to the over
all
output. T
his means that
the treble will be applied to both music and microphone vocals
.
1. Turn the TREBLE control clockwise towards +12 to boost the amount of treble
2. Set the TREBLE control to the center position or 0 for a flat tone or no treble
3. Turn the TREBLE control counter-clockwise towards -12 to cut the amount of
treble
Adjusting the
Bass Tone
The
bass control adjust
s how much bass or high-frequency is applied
to the
over
all
output. T
his means that
the bass will be applied to both music and
microphone vocals
.
1. Turn the BASS control clockwise towards +12 to boost the amount of bass
2. Set the BASS control to the center position or 0 for a flat tone or no bass
3. Turn the BASS control counter-clockwise towards -12 to cut the amount
of bass
Operat
ions
OperationsOperat