User Manual

99
4. Press the connector's release lever.
5. Tilt the bottom of the connector off the terminal.
6. Lift the connector up and off the terminal.
Connecting and Disconnecting Remote Listening Devices
To connect a remote listening device to a terminal, perform the following steps:
1. Obtain a Talkman terminal audio cable. This cable is the one that has a red bend
relief above its connector and an audio jack on the other end.
Note: A remote listening device can also be connected to the terminal using either a
maintenance cable or a training cable.
2. Locate the red connection port on the terminal. This port is the one with the red
arrow above it on the terminal.
3. Hold the audio cable's connector so that its release lever is on the bottom.
4. Tilt the connector and insert the top of it into the top slot of the terminal's red
connection port.
5. With the top slot in place, tilt the connector down onto the terminal until the
release lever snaps into place on the connection port.
6. Plug the connector at the end of the remote listening device's cable into the audio
jack at the end of the cable.
To disconnect a remote listening device from a terminal, perform the following steps:
1. Grasp the connector at the end of the device's cable in one hand and grasp the
audio cable's audio jack in the other.
2. Pull the device's connector out of the audio cable's audio jack.
3. Grasp the audio cable's connector.
Warning: Do not pull on the audio cable itself.
4. Press the connector's release lever.
5. Tilt the bottom of the connector off the terminal.
6. Lift the connector up and off the terminal.
Connecting and Disconnecting Visual Training Devices
To connect a visual training device to a terminal, perform the following steps:
1. Obtain a Talkman terminal training cable. This cable is the one that has a red bend
relief above its connector and both a training jack and an audio jack on the other
end.
2. Locate the red connection port on the terminal. This port is the one with the red
arrow above it on the terminal.
3. Hold the training cable's connector so that its release lever is on the bottom.
4. Tilt the connector and insert the top of it into the top slot of the terminal's red
connection port.
5. With the top slot in place, tilt the connector down onto the terminal until the
release lever snaps into place on the connection port.
6. Plug the connector at the end of the training cable into the visual training device.
To disconnect a visual training device from a terminal, perform the following steps:
1. Grasp the connector at the end of the training cable in one hand and grasp the
visual training device in the other.
2. Remove the cable's connector from the visual training device.
3. Grasp the training cable's connector.
Warning: Do not pull on the training cable itself.
4. Press the connector's release lever.
5. Tilt the bottom of the connector off the terminal.
6. Lift the connector up and off the terminal.