User's Manual Part 6

~;~~,;~:~-

.~;~1:;i~i.;i.

:1!:.

Talkman@ Open Operator's Guide

Removing Battery from Talkman

To remove the battery from Talkman:

1. Turn offTalkman by pressing and holding d1e yellow

play / pause button until d1e T a1kman tetminalIED goes

from solid red to off.

,0;'

w ARNIN G:

Do not remove battery when the Ta1kman

tenninal is only paused (blinking green

LED). All data gathered will be lost!

2. Hold Talkman in one hand with the buttons facing up. Place

your other hand under the battery while pressing down on

the battery release button. The battery should slide off

T alkman.

c~,

"0."

t:i';

C""

:f~

3. If the battery does not release on its own, hold down the

battery release button while sliding the battery down from

the Talkman terminal with your other hand

~~~~

1. Ensure iliat the Talkman cradle is powered. When powered,

the Talkman cradle power light will be lit.

.;;

2. Place dle Talkman terminal in dle TaJkman cradle as shown

in Figure 5-3.

3. The Talkman tem1inal is ready for use when the status light

on the Talkman terminal turns a solid or flashing green. A

flashing red LED means that the T alkman tem1inal is not

ready to be used (for example, the Talkman terminal is

communicating over the RF network). If the Talkman

tem1inal continuously displays a solid red light, contact your

syst~ administrator.

-..

~..

;

-"I