User's Manual Part 5

Talkman@ Open Operator's Guide

.Press the yellow play/pause button or

.Say, "Talkman, Sleep."

NOTE: The LED will blink green when the Talkman tenninal

is paused.

Either will tell the Talkman terminal to stop speaking and listening.

The only way to start the Talkman terminal after pausing it is to press

the yellow play / pause button again. The Talkman temlinal

remembers where you were if you pause in the middle of collecting

data. So if you are collecting data, and pause Talkman, when you turn

it back on, it asks the current unanswered question.

Also, if you don't speak to the Talkman terminal for a while, it will

turn itself off. It says, "Goodnight" and stops listening. This way if

you forget to turn it off, it knows to turn itself off. The default setting

for how long the Talkman will wait for an answer before

automatically pausing is 60 seconds. This setting may be changed by

your system administrator.

When you turn the Talkman tenninal back on by pressing the yellow

play/pause button, it remembers where you left off and repeats the

last unanswered or partially answered question.

Do not remove the battery from a paused Talkman

tenninal. You will lose data that you collected. You

must Stop the Talkman terminal. (See next section.)

Warnmg.

Stopping the Talkman Terminal

To stop the Talkman Terminal, hold the play/pause button down

until the LED turns red and then off.

When you are sure that the Talkman tenninal is turned off, you can

remove the battery and replace it with a fully charged battery.

~~iifi