User's Manual Part 5

Talkman@ Open Operator's Guide
range or connect fue Talkman tI~nninalto the PC and try
agatn.
Changing a Task
Oftentimes, a single Talkman terminal can be used with a number of
different tasks. Only one task is active' at a single rime, so you will
need to change tasks to run a different' task than is currently loaded.
Of course, your site has to have more than one task for you to be
able to change tasks.
To change a task:
1
The Talkman termina.l's U~D must be blinking green
(meaning Talkman is paus(~d). If it is on (LED is solid
een, ause it by pressin~; the yellow play/pause button.
2.
Press the gray operator button
The Talkman terminal will say:
The Talkman terminal then retrieves t11e list of available tasks. It may
take a few moments for this occur. T11en the Talkman temllna1 says,
until the
Press the gray plus/minus buttons
Talkman temlinal speaks the co~ect task name
4.
Press the gray operator button again. It will take a few
moments for the new task to be loaded. During this time, the
Talkman terminal says:
~
c c
Lbadi
n rTcctask.
cccc c ~ccC ccc
34
~