User's Manual Part 5

Talkman@ Open Operator's Guide
Each time you say, "louder" or "softer," the Talkman terminal
repeats your voice command at a slightly louder or softer volume.
When you are comfortable with the volume, say "continue". the
Talkman tenninal then repeats the cU!1~ent question or instruction at
the new volume setting.
For example, you can say "Talkman, V.olume, Louder, Louder,
Softer, Continue." In this case, the volwne is set one level higher.
Different operators can use the same Talkman terminal at different
times. Only one operator is active at a time, meaning only one
person can talk to the Talkman terminal at a time. Changing the
active operator can be done while you are in radio range. To change
the active operator, the Talkman terminal's LED must be solid green
(meaning the Talkman terminal is on).
-
f;;
~
, "
-
-
,.dji
Do the following to change the active operator:
Press the gray operator button on the Talkman terminal
1
The Talkman temlinal says
to scroll through
2.
While it retrieves a list of all operal:ors that have been assigned to
it. It may take a few moments for this to occur.
Press the gray plus/minus buttons
the list of available operator name5;.
3. Press the gray operator button again once you hear your
name. It will take a few moments for the new active operator to
loaded. The Talkman terminal says:
;
-.
;
jt
This tells you that it is going to' load your voice patterns.
Then the Talkman terminal says:
~
32