User's Manual Part 4

:\: ~

Talkman@ Open Operator's Guide

Plugging the Headset into the Talkman

Terminal

Plug the headset into the center yellow headset connection on the

Talkman tern1inal. The connectors on the Talkman terminal and the

headset have a small red dot on them. These dots should line up

with each other. Note that the connector on the Talkman terminal

has a picture of a headset above it to help you identify the correct

connector. There is also a yellow band around the base of the

headset connector and a yellow bend relief on the headset cable to

further identify the connection.

'01

:0;;;;

.",

Do the following to connect the headset to the Talkman:

.Align the red dot on the connector on the headset cable with the

red dot above the Talkman headset connector. This is the center

connector with the yellow ring around it and a picture of a

headset above it. Insert the headset connector straight in (don't

twist) until it is firmly seated.

To disconnect the headset:

.Grasp the ridges located on the headset connector, (NOT the

cable) and pull straight out (don't twist).

w ARNIN G:

Pulling on the cable or twisting will cause

damage to the headset.

Starting the Talkman

Press the yellow play / pause button on T alkman.

If the Talkman terminal is operating properly, the status light will

turn red for a few moments, but will eventually change to green.

You should NQI see or hear any of the following:

;

.".

;;'

;:#

Low battery warning

Warning beeps or messages

~!\!~~