User's Manual

Figure 5: Inserting a T2 Series Device Into a Charger
7. After the wearable computer has been placed into the charger, make sure that the LED indicator on the wearable
computer turns on and begins to blink green.
a) If the LED does not turn on after 30 seconds, remove the wearable computer from the charger slot and then place
it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Charging a T1 Battery in a Device
1. Remove the wearable computer from the holster.
2. Disconnect the headset from the wearable computer.
3. Insert the wearable computer into an open slot on the charger.
4. After the wearable computer has been placed into the charger, make sure that the LED indicator on the wearable
computer turns on and is green.
a) If the LED does not turn on after 30 seconds, remove the wearable computer from the charger slot and then place
it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Caution: Do not attempt to place the device into the charger unless you have first disconnected the headset.
Turning a Talkman Wearable Computer On
Before you turn on a wearable computer, make sure a headset and charged battery are properly connected to it.
1. Press the Play/Pause button on the wearable computer.
The LED indicator first turns solid red while the processor reboots. It then flashes red and green, turns solid, blinks
red, then turns solid green (T5-series and T2-series) or The LED indicator turns solid green (T1).
OpenTopic | Talkman
®
Devices | 21