User's Manual

5. Press the + button or — button to scroll through the list of operator teams until you hear the name of a team to which
you belong.
6. Press the operator button.
The device says, "Please wait" and retrieves a list of all operators who belong to the team that was selected. The
device then says, "Current operator is (operator name). Select new operator."
7. Press the + button or — button to scroll through the list of available operator names until you hear your name.
• If you do not hear your name, press the yellow play/pause button to cancel this operation and start over from step
2.
• When selecting a team in step 6, choose the "All Operators" team.When selecting a team in step 6, choose the
"All Operators" team.
• Consult with your supervisor if you are not listed in the "All Operators" team.
8. Press the operator button.
The device says, "Loading operator" and loads your templates. Once it has loaded your templates, the device says,
"Current operator is (your operator name). Good night." The device then goes to sleep. The next time you turn the
device on, it will be ready to use.
Charging a T5 Battery in a Device
1. Remove the wearable computer from the belt clip.
2. Disconnect any other peripherals.
3. Insert the wearable computer into an open slot on the charger, pressing down and then back until the wearable
computer clicks into place.
4. After the wearable computer has been placed into the charger, make sure that the LED indicator on the wearable
computer turns on and begins to blink green.
a) If the LED does not turn on after 30 seconds, remove the wearable computer from the charger slot and then place
it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Caution: Do not attempt to place the device into the charger unless you have first disconnected the headset and
any other peripheral devices. Do not remove the battery from the device when placing a device into a charger.
Charging a T2 Series Device
1. Make sure the charger is powered. The charger's orange power light (LED indicator) is lit when the charger is
powered.
2. Sign off of the device if necessary.
3. Press and hold the yellow play/pause button until the LED indicator turns solid red and then turns off.
4. Remove the device from the belt clip.
5. Disconnect any other peripherals. If the device is in a cover, remove the cover.
6. Insert the device into one of the device charger slots with the button controls of the device to the top and facing
toward the left.
20 | OpenTopic | Talkman
®
Devices