User's Manual

Removing a T2 or T5 Series Device From a Charger
Note: The device is ready to use when the LED indicator on the device is blinking green. If the LED is blinking
red, the device is not ready to be used.
Important: If a device continuously displays a solid red light, contact your system administrator.
1. Make sure that the device is ready to use.
2. Pull up on the device to remove it from the device charger.
Figure 27: Removing a Device from a Charger
Removing a T1 Device From a T1 5-Bay Charger
Note: The device is ready to use when the LED indicator on the device is green. If the LED is amber, the device
is not ready to be used.
Important: If a device displays a solid red light, contact your system administrator.
1. Make sure that the device is ready to use.
2. Pull up on the device to remove it from the device charger.
Disconnecting a T1 Device from a T1 Single Charger Cable
Note: The device is ready to use when the LED indicator on the device is green. If the LED is amber, the device
is not ready to be used.
Important: If a device's LED continuously displays red, contact your system administrator.
1. Unplug the charger from the electrical outlet.
2. Gently remove it from the T1 device by squeezing the sides of the I/O connector on the cable. Do not pull the cable
wire.
56 | OpenTopic | Batteries