User's Manual
Table Of Contents
- Contents
- About Honeywell Documentation
- Introduction
- Using the Talkman A500
- Charging an A500 or T5 Device
- Charging an A500 or T5 Battery in a Device
- Charging an A500 or T5-Series Battery
- Removing an A500, T2-Series or T5-Series Device From a Charger
- Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
- Removing a Battery from a Talkman A500, T5-Series or T2-Series Device
- Battery Warm-Up Time
- Easy Configuration
- Turning a Talkman Device On
- Turning a Talkman Device Off
- About LED Indicators
- Loading an Operator's Templates
- Adjusting the Voice
- Understanding Talkman Commands
- Options for Hearing Impaired Users
- Cleaning Procedures for Honeywell Equipment
- Charging an A500 or T5 Device
- Talkman A500 VMT
- Mounts for Talkman A500/T5 VMT
- Talkman A500/T5 VMT Accessories
- Positioning the Talkman A500/T5 VMT
- Installing the Mounting Brackets for a Talkman A500/T5 VMT
- Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
- Connecting the A500/T5 VMT Device to a Vehicle's Power Source
- Removal of an A500/T5 VMT Device from Vehicle
- VMT Installation Best Practices
- Chargers
- Troubleshooting Equipment Problems
- I Can't Hear Anything Through the Headset
- The Scanner will not Scan
- The Device Beeps Every Few Seconds
- The Device Will Not Load a Voice Application
- The Device Will Not Load an Operator Template
- The Device Does Not Respond to Button Presses
- The Device Will Not Turn On
- The Device Keeps Shutting Off
- Troubleshooting Guide for the Talkman A500/T5 Battery Charger
- Troubleshooting Problems Indicated by LED
- About Error Messages
- Contacting Technical Support
- About Sending Equipment Back for Repairs
- Troubleshooting VMT Configurations
- Specifications
- Accessories
- Part Numbers
- Template Training Options
- Compliance
- Index
T5/A500 Elastomer-SKIN Cover Specifications
ThermoPlastic Elastomer (Dynaflex G2755)Fabric
Putting a Cover on an A500 or T5-Series Device
1.
If the device is not already off, press and hold the yellow play/pause button until the LED indicator turns
solid red and then off.
2.
Disconnect any peripherals.
3.
Hold the device with the battery compartment facing up and the device's buttons facing toward you.
4.
Slide the open end of the cover over the connection port end of the device. Pull gently on the cover to
make sure it slides behind the tab, located on the bottom of the device, that holds the cover securely in
place.
Figure 36: Putting a Cover on a Talkman T5-Series Device
5.
Stretch the rounded end of the cover over the rounded end of the device.
6.
Attach the peripherals that you will be using.
Talkman A500/T5 VMT Accessory Specifications
-30° to 50° C (-22° to 122° F)Operating Temperature
-40° to 70° C (-40° to 158° F)Storage Temperature
Confidential: For informational use by Honeywell resellers and customers only
70 | Vocollect Talkman A500 Product Guide