User's Manual
Table Of Contents
- Contents
- About Honeywell Documentation
- Introduction
- Using the Talkman A500
- Charging an A500 or T5 Device
- Charging an A500 or T5 Battery in a Device
- Charging an A500 or T5-Series Battery
- Removing an A500, T2-Series or T5-Series Device From a Charger
- Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
- Removing a Battery from a Talkman A500, T5-Series or T2-Series Device
- Battery Warm-Up Time
- Easy Configuration
- Turning a Talkman Device On
- Turning a Talkman Device Off
- About LED Indicators
- Loading an Operator's Templates
- Adjusting the Voice
- Understanding Talkman Commands
- Options for Hearing Impaired Users
- Cleaning Procedures for Honeywell Equipment
- Charging an A500 or T5 Device
- Talkman A500 VMT
- Mounts for Talkman A500/T5 VMT
- Talkman A500/T5 VMT Accessories
- Positioning the Talkman A500/T5 VMT
- Installing the Mounting Brackets for a Talkman A500/T5 VMT
- Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
- Connecting the A500/T5 VMT Device to a Vehicle's Power Source
- Removal of an A500/T5 VMT Device from Vehicle
- VMT Installation Best Practices
- Chargers
- Troubleshooting Equipment Problems
- I Can't Hear Anything Through the Headset
- The Scanner will not Scan
- The Device Beeps Every Few Seconds
- The Device Will Not Load a Voice Application
- The Device Will Not Load an Operator Template
- The Device Does Not Respond to Button Presses
- The Device Will Not Turn On
- The Device Keeps Shutting Off
- Troubleshooting Guide for the Talkman A500/T5 Battery Charger
- Troubleshooting Problems Indicated by LED
- About Error Messages
- Contacting Technical Support
- About Sending Equipment Back for Repairs
- Troubleshooting VMT Configurations
- Specifications
- Accessories
- Part Numbers
- Template Training Options
- Compliance
- Index
4.
Put your left hand through the small loop and slide the harness over your left shoulder.
5.
Clip the large loop in front of your chest.
6.
Adjust the straps.
7.
Connect the device to the shoulder harness clip by sliding the device onto the clip until it snaps into place.
The device is properly clipped in place if you cannot remove it from the clip without pressing the device's
clip release button.
Belts and Belt Clips
To comply with government safety standards, the device must be used with a Vocollect customized belt and
clip, a Vocollect customized shoulder harness, or a Vocollect belt holder.
Figure 33: Belt with Clip
Using the A500/T-Series Belts and Clips
To wear a device using the belt and clip option, attach the device to a Vocollect belt with a specially designed
mounting clip (provided with the belt or harness):
• T5/A500 Black Belt Clip connects a T5 or A500 device to the belt.
• Attach the clip to the Vocollect belt at the beginning of a shift. You can attach the device to and remove
the device from the clip as often as necessary throughout the shift.
Figure 34: Attaching the Device to a Belt Clip
Confidential: For informational use by Honeywell resellers and customers only
68 | Vocollect Talkman A500 Product Guide