User's Manual
Table Of Contents
- Contents
- About Honeywell Documentation
- Introduction
- Using the Talkman A500
- Charging an A500 or T5 Device
- Charging an A500 or T5 Battery in a Device
- Charging an A500 or T5-Series Battery
- Removing an A500, T2-Series or T5-Series Device From a Charger
- Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
- Removing a Battery from a Talkman A500, T5-Series or T2-Series Device
- Battery Warm-Up Time
- Easy Configuration
- Turning a Talkman Device On
- Turning a Talkman Device Off
- About LED Indicators
- Loading an Operator's Templates
- Adjusting the Voice
- Understanding Talkman Commands
- Options for Hearing Impaired Users
- Cleaning Procedures for Honeywell Equipment
- Charging an A500 or T5 Device
- Talkman A500 VMT
- Mounts for Talkman A500/T5 VMT
- Talkman A500/T5 VMT Accessories
- Positioning the Talkman A500/T5 VMT
- Installing the Mounting Brackets for a Talkman A500/T5 VMT
- Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
- Connecting the A500/T5 VMT Device to a Vehicle's Power Source
- Removal of an A500/T5 VMT Device from Vehicle
- VMT Installation Best Practices
- Chargers
- Troubleshooting Equipment Problems
- I Can't Hear Anything Through the Headset
- The Scanner will not Scan
- The Device Beeps Every Few Seconds
- The Device Will Not Load a Voice Application
- The Device Will Not Load an Operator Template
- The Device Does Not Respond to Button Presses
- The Device Will Not Turn On
- The Device Keeps Shutting Off
- Troubleshooting Guide for the Talkman A500/T5 Battery Charger
- Troubleshooting Problems Indicated by LED
- About Error Messages
- Contacting Technical Support
- About Sending Equipment Back for Repairs
- Troubleshooting VMT Configurations
- Specifications
- Accessories
- Part Numbers
- Template Training Options
- Compliance
- Index
Figure 31: Connected to a Voice Device
Screens relevant to the application loaded onto the voice device will appear once the voice application is
running.
T5/A500 Adjustable Shoulder Harness
To comply with government safety standards, the device must be used with either a Vocollect customized
belt and clip, a Vocollect customized shoulder harness, or a Vocollect belt holder.
T5/A500 Adjustable Shoulder Harness Specifications
2" (5 cm) Wide Adjustable NylonShoulder Strap
Two Adjustable Elastic Nylon, 32"-48"(81 cm - 122 cm)Chest Straps (Regular)
Two Adjustable Elastic Nylon, 41"-66" (104 cm - 167 cm)Chest Straps (Large)
Putting a Device on a T5/A500 Shoulder Harness
To wear a device using the shoulder harness option, attach the device to an adjustable Vocollect harness
with a specially designed mounting clip (provided with the belt or harness).
Attach the clip to the harness at the beginning of a shift. You can attach the device to and remove the device
from the clip as often as necessary throughout the shift.
Figure 32: T5/A500 Shoulder Harness Properly Worn - Front and Back Views
1.
Open the flap on the front of the shoulder harness by unsnapping the two buttons.
2.
Slide the flap through the slots on the mounting clip then snap the buttons together.
3.
Unbuckle the large loop.
Confidential: For informational use by Honeywell resellers and customers only
Accessories | 67