User's Manual
Table Of Contents
- Contents
- About Honeywell Documentation
- Introduction
- Using the Talkman A500
- Charging an A500 or T5 Device
- Charging an A500 or T5 Battery in a Device
- Charging an A500 or T5-Series Battery
- Removing an A500, T2-Series or T5-Series Device From a Charger
- Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
- Removing a Battery from a Talkman A500, T5-Series or T2-Series Device
- Battery Warm-Up Time
- Easy Configuration
- Turning a Talkman Device On
- Turning a Talkman Device Off
- About LED Indicators
- Loading an Operator's Templates
- Adjusting the Voice
- Understanding Talkman Commands
- Options for Hearing Impaired Users
- Cleaning Procedures for Honeywell Equipment
- Charging an A500 or T5 Device
- Talkman A500 VMT
- Mounts for Talkman A500/T5 VMT
- Talkman A500/T5 VMT Accessories
- Positioning the Talkman A500/T5 VMT
- Installing the Mounting Brackets for a Talkman A500/T5 VMT
- Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
- Connecting the A500/T5 VMT Device to a Vehicle's Power Source
- Removal of an A500/T5 VMT Device from Vehicle
- VMT Installation Best Practices
- Chargers
- Troubleshooting Equipment Problems
- I Can't Hear Anything Through the Headset
- The Scanner will not Scan
- The Device Beeps Every Few Seconds
- The Device Will Not Load a Voice Application
- The Device Will Not Load an Operator Template
- The Device Does Not Respond to Button Presses
- The Device Will Not Turn On
- The Device Keeps Shutting Off
- Troubleshooting Guide for the Talkman A500/T5 Battery Charger
- Troubleshooting Problems Indicated by LED
- About Error Messages
- Contacting Technical Support
- About Sending Equipment Back for Repairs
- Troubleshooting VMT Configurations
- Specifications
- Accessories
- Part Numbers
- Template Training Options
- Compliance
- Index
If the steps don't work...Try these steps...If this occurs...
is placed in a slot and powers on.
This occurs in all slots.
Have the charger replaced or
repaired. This is not able to be
corrected by a customer.
Examine the charger slot to
determine whether there is a
mechanical alignment issue. There
should be little or no space
The battery charger slot’s LEDs
blink red immediately after a battery
or device with a battery is placed
into a battery or device slot.
between the front two plastic pegs
and the edge of the pocket. If an
item like a credit-card will fit in this
space, there may be an alignment
issue.
Send the battery to a Vocollect
Authorized Repair Center for
evaluation.
Determine if this issue only occurs
with one particular battery which is
not excessively old and other
batteries of approximately the same
age do not display this symptom.
Have the charger replaced or
repaired. This is not able to be
corrected by a customer.
Check to see if the contacts on the
device and charger are clean. If
not, follow cleaning procedures and
retry.
Dispose of the battery.Determine if this issue only occurs
with one particular battery that is
very old.
Have the charger replaced or
repaired. This is not able to be
corrected by a customer.
Check to see if the contacts on the
device and charger are clean. If
not, follow cleaning procedures and
retry.
The battery charger slot's LEDs
blink red 1.5 to 3 seconds after a
battery or device is placed into a
slot.
If battery is under warranty send
back for replacement.
Dispose of the battery.Determine if this issue only occurs
with one particular battery that is
very old.
If battery is under warranty send
back for replacement.
The battery charger slot’s LEDs
blink red more than 3 seconds after
a battery or device is placed into a
slot.
Dispose of the battery.Determine if this issue only occurs
with one particular battery that is
very old.
Have the charger replaced or
repaired. This is not able to be
corrected by a customer.
Check to see if the contacts on the
device and charger are clean. If
not, follow cleaning procedures and
retry.
All of the red LEDs for the battery
charger's slots are flashing and will
only stop if the charger's power is
cycled.
If the device is the problem, send
it back for repairs.
Replace all devices in the charger
with a different set of devices,
power cycle the charger and verify
if condition continues.
If the problem is a battery under
warranty, have it replaced.
Confidential: For informational use by Honeywell resellers and customers only
46 | Vocollect Talkman A500 Product Guide