User's Manual
Table Of Contents
- Contents
- About Honeywell Documentation
- Introduction
- Using the Talkman A500
- Charging an A500 or T5 Device
- Charging an A500 or T5 Battery in a Device
- Charging an A500 or T5-Series Battery
- Removing an A500, T2-Series or T5-Series Device From a Charger
- Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
- Removing a Battery from a Talkman A500, T5-Series or T2-Series Device
- Battery Warm-Up Time
- Easy Configuration
- Turning a Talkman Device On
- Turning a Talkman Device Off
- About LED Indicators
- Loading an Operator's Templates
- Adjusting the Voice
- Understanding Talkman Commands
- Options for Hearing Impaired Users
- Cleaning Procedures for Honeywell Equipment
- Charging an A500 or T5 Device
- Talkman A500 VMT
- Mounts for Talkman A500/T5 VMT
- Talkman A500/T5 VMT Accessories
- Positioning the Talkman A500/T5 VMT
- Installing the Mounting Brackets for a Talkman A500/T5 VMT
- Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
- Connecting the A500/T5 VMT Device to a Vehicle's Power Source
- Removal of an A500/T5 VMT Device from Vehicle
- VMT Installation Best Practices
- Chargers
- Troubleshooting Equipment Problems
- I Can't Hear Anything Through the Headset
- The Scanner will not Scan
- The Device Beeps Every Few Seconds
- The Device Will Not Load a Voice Application
- The Device Will Not Load an Operator Template
- The Device Does Not Respond to Button Presses
- The Device Will Not Turn On
- The Device Keeps Shutting Off
- Troubleshooting Guide for the Talkman A500/T5 Battery Charger
- Troubleshooting Problems Indicated by LED
- About Error Messages
- Contacting Technical Support
- About Sending Equipment Back for Repairs
- Troubleshooting VMT Configurations
- Specifications
- Accessories
- Part Numbers
- Template Training Options
- Compliance
- Index
The Device Beeps Every Few Seconds
1.
Wait for a few minutes. The voice engine may just be communicating with the host.
2.
If the beeping continues beyond a few minutes, see the administrator.
3.
The administrator can check device logs in VoiceConsole to attempt to diagnose the problem.
The Device Will Not Load a Voice Application
1.
Try loading the voice application again. See the VoiceConsole online help for instructions.
2.
Make sure the device is properly placed in a charger.
3.
Check for error messages in VoiceConsole.
4.
Make sure you are in radio range of an access point.
5.
Make sure the device's ChangeTaskEnabled parameter is set to 1.
6.
Reboot the device.
7.
Put the device in debug mode to look for a clue to the problem.
The Device Will Not Load an Operator Template
1.
Make sure you are loading the operator properly.
2.
Make sure the operator has created a voice template.
3.
Make sure you are in radio range.
4.
Reboot the device.
The Device Does Not Respond to Button Presses
1.
Make sure the device has a fully charged battery.
2.
Reboot the device.
3.
Send the device back to Vocollect for repair.
The Device Will Not Turn On
1.
Make sure the battery is properly seated on the device.
2.
Make sure the device has a fully charged battery.
3.
Send the device back to Vocollect for repair.
Confidential: For informational use by Honeywell resellers and customers only
44 | Vocollect Talkman A500 Product Guide