User's Manual
Table Of Contents
- Contents
- About Honeywell Documentation
- Introduction
- Using the Talkman A500
- Charging an A500 or T5 Device
- Charging an A500 or T5 Battery in a Device
- Charging an A500 or T5-Series Battery
- Removing an A500, T2-Series or T5-Series Device From a Charger
- Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
- Removing a Battery from a Talkman A500, T5-Series or T2-Series Device
- Battery Warm-Up Time
- Easy Configuration
- Turning a Talkman Device On
- Turning a Talkman Device Off
- About LED Indicators
- Loading an Operator's Templates
- Adjusting the Voice
- Understanding Talkman Commands
- Options for Hearing Impaired Users
- Cleaning Procedures for Honeywell Equipment
- Charging an A500 or T5 Device
- Talkman A500 VMT
- Mounts for Talkman A500/T5 VMT
- Talkman A500/T5 VMT Accessories
- Positioning the Talkman A500/T5 VMT
- Installing the Mounting Brackets for a Talkman A500/T5 VMT
- Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
- Connecting the A500/T5 VMT Device to a Vehicle's Power Source
- Removal of an A500/T5 VMT Device from Vehicle
- VMT Installation Best Practices
- Chargers
- Troubleshooting Equipment Problems
- I Can't Hear Anything Through the Headset
- The Scanner will not Scan
- The Device Beeps Every Few Seconds
- The Device Will Not Load a Voice Application
- The Device Will Not Load an Operator Template
- The Device Does Not Respond to Button Presses
- The Device Will Not Turn On
- The Device Keeps Shutting Off
- Troubleshooting Guide for the Talkman A500/T5 Battery Charger
- Troubleshooting Problems Indicated by LED
- About Error Messages
- Contacting Technical Support
- About Sending Equipment Back for Repairs
- Troubleshooting VMT Configurations
- Specifications
- Accessories
- Part Numbers
- Template Training Options
- Compliance
- Index
Chapter 4
Chargers
Vocollect offers charger units that can charge one or more batteries individually or while inserted in Talkman
devices.
Talkman devices should be placed into a charger when not in use. The charger charges the device's battery
while linking to the host computer to download new voice applications, reconfigure device settings, and update
device software.
Caution:
• Keep water and moisture away from the charger at all times. If a battery has any condensation from
use in a cold environment such as a freezer, dry the battery before placing it into the charger.
• Only Vocollect-approved batteries should be placed in the battery charger. Do not attempt to charge
any other type of battery in the charger.
Note:
• Do not place a device into a charger without a battery attached to it.
• A device is always on when it is in a charger. When a device that is powered off is placed into a charger,
it automatically turns on.
• The A700 series, A500/T5, and T1 chargers can charge batteries both inserted in and separate from
devices.
• Vocollect recommends that a protective device, such as an uninterruptible power supply with surge
protection and lightning arrestor capability, be used with battery chargers.
T5/A500 Combination Charger
Figure 24: T5/A500 10-Bay Combination Charger
• The T5/A500 10-Bay Combination Charger can store five devices at a time and any combination of T5,
T5m and A500 device models.
• The charger can store and charge ten batteries - five batteries in the upper battery slots and five batteries
connected to devices in the lower device slots.
• The charger can also share one device's configuration with other devices being charged at the same time.
Confidential: For informational use by Honeywell resellers and customers only