User's Manual
Table Of Contents
- Contents
- About Honeywell Documentation
- Introduction
- Using the Talkman A500
- Charging an A500 or T5 Device
- Charging an A500 or T5 Battery in a Device
- Charging an A500 or T5-Series Battery
- Removing an A500, T2-Series or T5-Series Device From a Charger
- Inserting a Battery into a Talkman A500, T5-Series or T2-Series Device
- Removing a Battery from a Talkman A500, T5-Series or T2-Series Device
- Battery Warm-Up Time
- Easy Configuration
- Turning a Talkman Device On
- Turning a Talkman Device Off
- About LED Indicators
- Loading an Operator's Templates
- Adjusting the Voice
- Understanding Talkman Commands
- Options for Hearing Impaired Users
- Cleaning Procedures for Honeywell Equipment
- Charging an A500 or T5 Device
- Talkman A500 VMT
- Mounts for Talkman A500/T5 VMT
- Talkman A500/T5 VMT Accessories
- Positioning the Talkman A500/T5 VMT
- Installing the Mounting Brackets for a Talkman A500/T5 VMT
- Connecting Cables to the Power Supply and Attaching the Power Supply to a Vehicle
- Connecting the A500/T5 VMT Device to a Vehicle's Power Source
- Removal of an A500/T5 VMT Device from Vehicle
- VMT Installation Best Practices
- Chargers
- Troubleshooting Equipment Problems
- I Can't Hear Anything Through the Headset
- The Scanner will not Scan
- The Device Beeps Every Few Seconds
- The Device Will Not Load a Voice Application
- The Device Will Not Load an Operator Template
- The Device Does Not Respond to Button Presses
- The Device Will Not Turn On
- The Device Keeps Shutting Off
- Troubleshooting Guide for the Talkman A500/T5 Battery Charger
- Troubleshooting Problems Indicated by LED
- About Error Messages
- Contacting Technical Support
- About Sending Equipment Back for Repairs
- Troubleshooting VMT Configurations
- Specifications
- Accessories
- Part Numbers
- Template Training Options
- Compliance
- Index
Figure 18: Attach the Power Supply
10.
Secure the wires with cable ties.
Removal of an A500/T5 VMT Device from Vehicle
Talkman A500/T5 VMT components are designed for easy removal for occasional vehicle service, maintenance
or flexible operational needs.
Caution: Vocollect does not recommend removing the cables (CM-710-101, CM-710-102) from the
battery adapter except when required for occasional service (i.e. once per month at maximum). Excessive
removal of these cables may damage the adapter and cable. This type of use is not covered under
warranty or service plans as it is unintended product use that is specifically not recommended.
1.
Release the battery adapter from the device.
2.
Dock the battery adapter in the side of the VMT holder.
This leaves the device free to be removed and the battery adapter and cable docked and protected.
Caution: The battery adapter should remain cabled and docked when not in use to prevent cable
damage or accidental contact of the adapter contacts with metal surfaces.
Confidential: For informational use by Honeywell resellers and customers only
Talkman A500 VMT | 35