User's Manual

Easy Configuration: Bringing Additional T5, T5m, and A500 Devices Online
A single device has been configured using the Easy Configuration Initial Setup instructions and VoiceConsole
Online Help. The following instructions are for configuring additional devices.
1.
Place a properly configured T5, T5m, or A500 device in the transmit bay in the charger. When facing the
charger bay, the transmit bay is the first bay on the right. It is identified with an off-white latch. The other
bays have dark gray latches.
2.
Place the new or repaired T5, T5m, or A500 devices in the remaining charger bays.
• The LED indicators on the unconfigured devices flash green until the devices determine that they
cannot reach VoiceConsole.
• The LED indicators flash orange as the devices attempt to connect to the network to listen for a file
broadcast.
• The LED indicators flash green briefly as the devices receive profiles from the configured device and
verify the configuration.
• The LED indicators change to solid red as the devices reboot.
• When the devices have applied the configuration file and successfully contacted VoiceConsole, the
LED indicators change to blinking green. The devices are then ready to use or can be used in another
charger to bring additional devices online.
Note: The AC power indicator at the bottom right of the charger displays alternating green and yellow
lights when Easy Configuration operations are occurring. Devices should not be removed until the
individual indicator on the device blinks green or the charger's power indicator glows solid green.
Turning a Talkman Device On
Before you turn on a device, make sure a headset and charged battery are properly connected to it.
1.
Press the Play/Pause button on the device.
The LED indicator differs depending on the device being used.
IndicatorDevice Type
The ring is yellow and rotates, then the ring segment
turns solid green.
A700 series
First turns solid red while the processor reboots. It
then flashes red and green, turns solid, blinks red,
then turns solid green.
T2 series, T5 series and A500
Turns solid greenT1
2.
The device says, "Current operator is operator name. Please keep quiet for a few seconds." The device
then starts a noise sample.
3.
After a brief pause, it says, "Please wait." After another pause, the device begins asking questions or
providing instructions.
Confidential: For informational use by Honeywell resellers and customers only
20 | Vocollect Talkman A500 Product Guide