User's Manual

3.
Lift the battery out of the compartment.
Battery Warm-Up Time
If a battery has been used in a cold environment, it will not begin charging until it warms up sufficiently.
Approximate warm-up timeTemperature of battery use
6 minutes-4°C (24.8°F)
10 minutes-10°C (14.0°F)
22 minutes-20°C (-4°F)
30 minutes-30°C (-22°F)
Easy Configuration
Easy Configuration uses the serial connection between bays in the T5/A500 Combination Charger to distribute
configuration files from one device to all devices in the charger. This feature allows new installations to quickly
complete initial device configuration and simplifies adding new devices or returning repaired devices to service.
Any of the supported device models - T5, T5m, and A500 - may be configured using this feature. Multiple
models may be configured in the charger at the same time. Please note, however, that some configurable
parameters are specific to a device's radio card. Therefore, some parameters loaded from the master device
to devices with different radios will not be effective, and devices that receive the distribution may not receive
all of the desirable parameters for their specific radios.
Note: Easy configuration should be used only with a DHCP server.
Easy Configuration: Initial Setup
The following instructions are for initially setting up the site. That is, no devices are currently connected to
VoiceConsole.
1.
Create a device profile in VoiceConsole.
You can set the device profile as a "default profile," which automatically loads to any bare-platform devices.
The devices must be in standby mode and connected to VoiceConsole.
Note: The Talkman A500 model TT-802 ships as a bare-platform device. It does not have Vocollect
voice software—VoiceCatalyst or VoiceClient—preloaded.
2.
In the Advanced Device Settings text box, type this parameter: "distributable"="1"
The value of "1" marks the device profile as one that can be shared with other devices using the serial
connection between bays in the T5/A500 charger. If this parameter is not placed in the device profile or
if its value is set to zero, the device profile will not be shared.
3.
Follow the instructions in the VoiceConsole online help for completing the device profile.
4.
Use a serial cable to load this profile to a single device.
Note: If the device profile you are loading is configured for use with static IP addresses, all the devices
will have the same IP address.
Confidential: For informational use by Honeywell resellers and customers only
Using the Talkman A500 | 19