User's Manual

Charging an A500 or T5 Device
Figure 2: Talkman A500/T5 High-Performance Battery
The A500/T5 battery is a high-performance model. Unlike the T2 series batteries, which have contact points
that are flush with the case, the A500/T5 battery features a pin-out design.
Caution: A500/T5 series batteries and other Vocollect batteries are not interchangeable. If you try to
insert the wrong battery into a device, you may damage the device and the battery.
The A500 and T5 devices use a Vocollect Combination Charger that charges the high-performance battery
while still seated in a device or when removed from the device.
Charging an A500 or T5 Battery in a Device
1.
Remove the device from the belt clip.
2.
Disconnect any other peripherals.
3.
Insert the device into an open slot on the charger, pressing down and then back until the device clicks
into place.
4.
After the device has been placed into the charger, make sure that the LED indicator on the device turns
on and begins to blink green.
a) If the LED does not turn on after 30 seconds, remove the device from the charger slot and then place
it into the slot again.
b) If the LED indicator still does not turn on, try another charger slot.
Caution: Do not attempt to place the device into the charger unless you have first disconnected the
headset and any other peripheral devices. Do not remove the battery from the device when placing a
device into a charger.
Charging an A500 or T5-Series Battery
1.
Remove the battery from the Talkman device.
2.
Hold the battery with its contacts to the bottom and the Vocollect label facing you.
Confidential: For informational use by Honeywell resellers and customers only
16 | Vocollect Talkman A500 Product Guide