User`s manual

Workstation User’s Manual
302 VMware, Inc.
Setting Up Two Separate Host-Only Networks
Setupmultiplehost‐onlynetworksonthesamehostcomputerinsituationssuchasthe
following:
 Tohavetwovirtualmachinesconnectedtoonehost‐onlynetwork,andother
virtualmachinesconnectedtoanotherhost‐onlynetworktoisolatethenetwork
trafficoneachnetwork.
 Totestroutingbetweentwovirtualnetworks.
 Totestavirtualmachinewithmultiplenetworkinterfacecards,withoutusingany
physicalnetworkadapters.
OnWindowsandLinuxhosts,thefirsthost‐onlynetworkissetupautomaticallywhen
youinstallWorkstation.Tosetupmultiplehost‐onlynetworksonWindowsandLinux
hostssee“ConnectorDisconnectaHostVi
rtualNetworkAdapter”onpage 301.
OnaLinuxhost,afterthehost‐onlynetworksaresetup,atleastfournetworkinterfaces
appear:eth0,lo,vmnet1,andvmnet2.Thesefourinterfacesshouldhavedifferent
IP addressesonseparatesubnets.