6.5.1

Table Of Contents
3
Under Storage, click Storage Adapters, and click the Add icon ( ).
4 Select Software iSCSI Adapter and confirm that you want to add the adapter.
The software iSCSI adapter (vmhba#) is enabled and appears on the list of storage adapters. After
enabling the adapter, the host assigns the default iSCSI name to it. If you need to change the default
name, follow iSCSI naming conventions.
What to do next
Select the adapter and use the Adapter Details section to complete configuration.
Modify General Properties for iSCSI Adapters
You can change the default iSCSI name and alias assigned to your iSCSI adapters. For the independent
hardware iSCSI adapters, you can also change the default IP settings.
Important When you modify any default properties for your iSCSI adapters, make sure to use correct
formats for their names and IP addresses.
Prerequisites
Required privilege: Host .Configuration.Storage Partition Configuration
Procedure
1 Browse to the host in the vSphere Web Client navigator.
2 Click the Configure tab.
3 Under Storage, click Storage Adapters, and select the adapter (vmhba#) to configure.
4 Under Adapter Details, click the Properties tab, and click Edit in the General panel.
5 (Optional) Modify the following general properties.
Option Description
iSCSI Name Unique name formed according to iSCSI standards that identifies the iSCSI
adapter. If you change the name, make sure that the name you enter is worldwide
unique and properly formatted. Otherwise, certain storage devices might not
recognize the iSCSI adapter.
iSCSI Alias A friendly name you use instead of the iSCSI name.
If you change the iSCSI name, it is used for new iSCSI sessions. For existing sessions, the new settings
are not used until you log out and log in again.
Set Up iSCSI Networking
If you use the software or dependent hardware iSCSI adapters, you must configure connections for the
traffic between the iSCSI component and the physical network adapters.
vSphere Storage
VMware, Inc. 84