6.5.1

Table Of Contents
n
Support ESXi open FCoE stack.
n
Contain FCoE boot firmware which can export boot information in FBFT format or FBPT format.
Considerations
n
You cannot change software FCoE boot configuration from within ESXi.
n
Coredump is not supported on any software FCoE LUNs, including the boot LUN.
n
Multipathing is not supported at pre-boot.
n
Boot LUN cannot be shared with other hosts even on shared storage.
Best Practices for Software FCoE Boot
When you boot your system from a software FCoE LUN, specific guidelines apply.
n
Make sure that the host has access to the entire boot LUN. The boot LUN cannot be shared with
other hosts even on shared storage.
n
If you use Intel 10 Gigabit Ethernet Controller with a Cisco switch, configure the switch port in the
following way:
n
Enable the Spanning Tree Protocol (STP).
n
Turn off switchport trunk native vlan for the VLAN used for FCoE.
Set Up Software FCoE Boot
Your ESXi host can boot from a FCoE LUN using the software FCoE adapter and a network adapter.
When you configure your host for a software FCoE boot, you perform several tasks.
Prerequisites
The network adapter has the following capabilities:
n
Support partial FCoE offloads (software FCoE).
n
Contain either a FCoE Boot Firmware Table (FBFT) or a FCoE Boot Parameter Table (FBPT).
For information about network adapters that support software FCoE boot, see the VMware Compatibility
Guide.
Procedure
1 Configure Software FCoE Boot Parameters
To support a software FCoE boot process, a network adapter on your host must have a specially
configured FCoE boot firmware. When you configure the firmware, you enable the adapter for the
software FCoE boot and specify the boot LUN parameters.
2 Install and Boot ESXi from Software FCoE LUN
When you set up your system to boot from a software FCoE LUN, you install the ESXi image to the
target LUN. You can then boot your host from that LUN.
vSphere Storage
VMware, Inc. 58