6.7

Table Of Contents
Step Description
Activate or Disable the Software
iSCSI Adapter
Activate your software iSCSI adapter so that your host can use it to access iSCSI storage.
Modify General Properties for iSCSI
or iSER Adapters
If needed, change the default iSCSI name and alias assigned to your adapter.
Configure Port Binding for iSCSI or
iSER
Configure connections for the traffic between the iSCSI component and the physical
network adapters. The process of configuring these connections is called port binding.
Configure Dynamic or Static
Discovery for iSCSI and iSER
Set up dynamic discovery. With dynamic discovery, each time the initiator contacts a
specified iSCSI storage system, it sends the SendTargets request to the system. The iSCSI
system responds by supplying a list of available targets to the initiator. In addition to the
dynamic discovery method, you can use static discovery and manually enter information for
the targets.
Set Up CHAP for iSCSI or iSER
Adapter
If your iSCSI environment uses the Challenge Handshake Authentication Protocol (CHAP),
configure it for your adapter.
Set Up CHAP for Target You can also configure different CHAP credentials for each discovery address or static
target.
Enable Jumbo Frames for
Networking
If your iSCSI environment supports Jumbo Frames, enable them for the adapter.
Activate or Disable the Software iSCSI Adapter
You must activate your software iSCSI adapter so that your host can use it to access iSCSI storage. If
you do not need the software iSCSI adapter, you can disable it.
You can activate only one software iSCSI adapter.
Prerequisites
Required privilege: Host.Configuration.Storage Partition Configuration
Note If you boot from iSCSI using the software iSCSI adapter, the adapter is enabled and the network
configuration is created at the first boot. If you disable the adapter, it is reenabled each time you boot the
host.
Procedure
1 Navigate to the host.
2 Click the Configure tab.
vSphere Storage
VMware, Inc. 83