6.5.1

Procedure
1 In a PowerCLI session, run the Connect-VIServer cmdlet to connect to the vCenter Server system
that vSphere Auto Deploy is registered with.
Connect-VIServer ipv4_or_ipv6_address
The cmdlet might return a server certificate warning. In a production environment, make sure no
server certificate warnings result. In a development environment, you can ignore the warning.
2 Define a rule in which hosts with certain attributes, for example a range of IP addresses, are assigned
to a folder or a cluster.
New-DeployRule -Name testrule3 -Item "my folder" -Pattern "vendor=Acme,Zven", "ipv4=192.XXX.
1.10-192.XXX.1.20"
This example passes in the folder by name. You can instead pass in a folder, cluster, or data center
object that you retrieve with the Get-Folder, Get-Cluster, or Get-Datacenter cmdlet.
3 Add the rule to the rule set.
Add-DeployRule testrule3
By default, the working rule set becomes the active rule set, and any changes to the rule set become
active when you add a rule. If you use the NoActivate parameter, the working rule set does not
become the active rule set.
What to do next
n
Assign a host already provisioned with vSphere Auto Deploy to the new folder or cluster location by
performing test and repair compliance operation. See Test and Repair Rule Compliance.
n
Power on unprovisioned hosts to add them to the specified vCenter Server location.
Configure a Stateless System by Running a Custom Script
You can use vSphere Auto Deploy to configure one or more hosts by associating custom scripts with a
vSphere Auto Deploy rule.
The scripts run in alphabetical order after the initial ESXi boot workflow of the host.
Prerequisites
n
Prepare your system for vSphere Auto Deploy. For more information, see vSphere Installation and
Setup.
n
Verify that the script bundle you want to associate with a vSphere Auto Deploy rule is in .tgz format,
with a maximum size of 10 MB, and written in Python or BusyBox ash scripting language.
vSphere Installation and Setup
VMware, Inc. 133