7.3

c For Hostname, enter the appliance FQDN.
For best results, enter the FQDN even if using DHCP.
Note vRealize Automation supports DHCP, but static IP addresses are recommended for
production deployments.
d In Network Properties, when using static IP addresses, enter the values for gateway, netmask,
and DNS servers. You must also enter the IP address, FQDN, and domain for the appliance itself,
as shown in the following example.
Figure 3‑1. Example Virtual Appliance Properties
12 Depending on your deployment, vCenter Server, and DNS configuration, select one of the following
ways of finishing deployment and powering up the appliance.
n
If you deployed to vSphere, and Power on after deployment is available on the Ready to
Complete page, take the following steps.
a Select Power on after deployment and click Finish.
b After the file finishes deploying into vCenter Server, click Close.
Installing vRealize Automation
VMware, Inc. 37