System information

16 Dialogic
®
HMP Software Release 3.0WIN Release Guide — December 2010
Dialogic Corporation
System Requirements
IP Network Interface: 100 Base-T Network Interface Card (NIC)
Note: For 120 channels or higher, using a 1000Base-T NIC, while still using a
100Base-T Network, is recommended. In general, better performance will be
realized by using a 1000Base-T NIC, even for configurations of less than 120
channels.
Dialogic
®
DNI Boards and Physical Address Extension (PAE): PAE is not supported
on servers having over 4 GB of RAM with a Dialogic
®
DNI board PCIe form factor and
over 2 GB of RAM with a Dialogic
®
DNI board PCI form factor. If these configurations
are present, then the Dialogic
®
HMP system will not start. To prevent this, PAE must
be disabled.
Run the following commands to disable PAE for Windows
®
7 or Windows Server
®
2008 operating systems:
bcdedit /set pae ForceDisable
bcdedit /set nx AlwaysOff
Note: Setting “nx” to “AlwaysOff” will disable Data Execution Prevention (DEP).
When DEP is enabled, Windows also enables PAE on machines that are
capable of supporting PAE. When PAE is enabled, Windows may use 36-bit
physical addressing instead of 32-bit, depending on the machine memory.
2.2 Basic Software Requirements
Note: Dialogic
®
HMP Software Release 3.0WIN has been tested only on systems with NT file
systems (NTFS). This release of the Dialogic
®
HMP Software has not been tested on
systems with FAT 32 file systems.
Table 1. Processor Recommendations
Number of User
Sessions
1
Processor Type and Clock Speed
G.711 (20 msec Frame) G.729AB
2
Up to 64 Intel Pentium 4, 2.0 GHz Dual Intel Xeon, 2.0 GHz
Up to 96 Single Intel Xeon, 2.4 GHz Dual Intel Xeon, 3.06 GHz
Up to 120 Dual Intel Xeon, 2.4 GHz Dual Intel Xeon, 3.2 GHz w/HT or
Dual Core Extreme 3.2 GHz w/HT
Up to 200 Dual Intel Xeon, 3.06 GHz Dual Intel Xeon, 3.6 GHz w/HT or
Dual Core Extreme 3.2 GHz w/HT
Up to 500 Dual Intel Xeon, 3.6 GHz w/HT or
Dual Core Extreme, 3.2 GHz w/HT
Up to1000
3
Quad Core Intel Xeon, W5580, 3.2 GHz
w/HT
1.RTP and Voice functionality
2.Two frames per packet
3.For Windows
®
7 or Windows Server
®
2008 operating systems