6.7

11 Wait for the OVA deployment to finish, and click Continue to proceed with stage 2 of the deployment
process to set up and start the services of the newly deployed appliance.
Note If you exit the wizard by clicking Close, you must log in to the Platform Services Controller
Appliance Management Interface to set up and start the services.
The newly deployed Platform Services Controller appliance is running on the target server but the
services are not started.
Stage 2 - Set up the Newly Deployed Platform Services Controller Appliance
When the OVA deployment finishes, you are redirected to stage 2 of the deployment process to set up
and start the services of the newly deployed Platform Services Controller appliance.
Procedure
1 Review the introduction to stage 2 of the deployment process and click Next.
2 Configure the time settings in the appliance, optionally enable remote SSH access to the appliance,
and click Next.
Option Description
Synchronize time with the ESXi host Enables periodic time synchronization, and VMware Tools sets the time of the
guest operating system to be the same as the time of the ESXi host.
Synchronize time with NTP servers Uses a Network Time Protocol server for synchronizing the time. If you select this
option, you must enter the names or IP addresses of the NTP servers separated
by commas.
vCenter Server Installation and Setup
VMware, Inc. 53