6.0.1

The host might also display the following details:
Details: This host has been added to VC, but no Image Profile
is associated with it. You can use Apply-ESXImageProfile in the
PowerCLI to associate an Image Profile with this host.
Alternatively, you can reevaluate the rules for this host with the
Test-DeployRuleSetCompliance and Repair-DeployRuleSetCompliance cmdlets.
The console then displays the host's machine attributes including vendor, serial number, IP address, and so
on.
Cause
No image profile is currently associated with this host.
Solution
You can temporarily assign an image profile to the host by running the Apply-EsxImageProfile cmdlet.
You can permanently assign an image profile to the host as follows.
1 Run the New-DeployRule cmdlet to create a rule that includes a pattern that matches the host with an
image profile.
2 Run the Add-DeployRule cmdlet to add the rule to a ruleset.
3 Run the Test-DeployRuleSetCompliance cmdlet and use the output of that cmdlet as the input to the
Repair-DeployRuleSetCompliance cmdlet.
Auto Deploy Host Cannot Contact TFTP Server
The host that you provision with Auto Deploy cannot contact the TFTP server.
Problem
When you attempt to boot a host provisioned with Auto Deploy, the host performs a network boot and is
assigned a DHCP address by the DHCP server, but the host cannot contact the TFTP server.
Cause
The TFTP server might have stopped running, or a firewall might block the TFTP port.
Solution
n
If you installed the WinAgents TFTP server, open the WinAgents TFTP management console and verify
that the service is running. If the service is running, check the Windows firewall's inbound rules to
make sure the TFTP port is not blocked. Turn off the firewall temporarily to see whether the firewall is
the problem.
n
For all other TFTP servers, see the server documentation for debugging procedures.
Auto Deploy Host Cannot Retrieve ESXi Image from Auto Deploy Server
The host that you provision with Auto Deploy stops at the iPXE boot screen.
Problem
When you attempt to boot a host provisioned with Auto Deploy, the boot process stops at the iPXE boot
screen and the status message indicates that the host is attempting to get the ESXi image from the Auto
Deploy server.
Cause
The Auto Deploy service might be stopped or the Auto Deploy server might be unaccessible.
vSphere Troubleshooting
30 VMware, Inc.