6.5
Table Of Contents
- Administrator Guide
- Contents
- About This Book
- Introduction
- Configuring vCenter Server Heartbeat
- Server Protection
- Checking the Server Pair Status
- Monitoring the Status of Servers
- Configuring Heartbeat Settings
- Network Protection
- Application Protection
- Applications: Summary Tab
- Resetting the Application Health Status
- Viewing Application Status
- Setting the Application Timeout Exception
- Remove an Application
- Manually Stop and Start Applications
- Configuring Applications
- Application Maintenance Mode
- Reviewing the State of an Application
- Reviewing the Applications Log
- Filtering Application Log Entries
- Applications: Services Tab
- Applications: Tasks Tab
- Applications: Plug-ins Tab
- Applications: Summary Tab
- Status and Control
- About vCenter Server Heartbeat Console
- Working with Groups
- Working with Pairs in vCenter Server Heartbeat Groups
- Reviewing the Status of vCenter Server Heartbeat Groups and Pairs
- Exiting vCenter Server Heartbeat Console
- Shutting Down Windows Without Stopping vCenter Server Heartbeat
- Controlled Shutdown
- vSphere Web Client Plug-in
- Uninstalling vCenter Server Heartbeat
- Performance Protection
- Data Protection
- Alerts and Events
- Troubleshooting
- Two Active or Two Passive Servers
- Synchronization Failures
- Registry Status is Out-of-Sync
- Channel Drops
- Performance Issues
- Passive Server Does Not Meet Minimum Hardware Requirements
- Hardware or Driver Issues on VMware Channel NICs
- Firewall Connection
- Channel Fails to Connect After Configuring Firewall Ports
- Incorrect VMware Channel Configuration
- VMware vCenter Server Heartbeat Packet Filter Is Enabled on the Channel NIC(s)
- Subnet or Routing Issues
- MaxDiskUsage Errors
- Application Slowdown
- Glossary
Setting Max Server Time Difference
vCenter Server Heartbeat generates a warning if the Primary and Secondary server system clocks are not
synchronized. The threshold for time dierence can be congured on the Server: Summary page.
Procedure
1 Select the Server: Summary tab and click Congure to display the Server: Summary Congure dialog.
2 Type a number (seconds) or use the arrow buttons to select an alert threshold value for time dierence
between servers, which is checked at handshake following startup.
3 Click OK.
VMware, Inc. 43
Chapter 4 Network Protection