6.4
Table Of Contents
- Administrator Guide
- Contents
- About This Book
- Getting Started
- Introduction
- Configuring vCenter Server Heartbeat
- System Administration and Management
- Server Protection
- Network Protection
- Application Protection
- Application Protection Overview
- Applications: Applications Tab
- Reset the Application Health Status
- View Application Status
- Setting the Application Timeout Exception
- Remove an Application
- Manually Start and Stop Applications
- Configuring Applications
- Application Maintenance Mode
- Reviewing the State of an Application
- Reviewing the Applications Log
- Filtering Application Log Entries
- Applications: Services Tab
- Applications: Tasks Tab
- Applications: Plug-ins Tab
- Status and Control
- vCenter Server Heartbeat Console
- About vCenter Server Heartbeat Console
- Work with Groups and Pairs
- Add, Edit, Move, and Remove Pairs in VCenter Server Heartbeat Groups
- Review the Status of vCenter Server Heartbeat Groups and Pairs
- Exit vCenter Server Heartbeat Console
- Shut Down Windows Without Stopping vCenter Server Heartbeat
- Controlled Shutdown
- vSphere Client Plug-in
- Uninstall vCenter Server Heartbeat
- Performance Protection
- Data Protection
- Alerts and Events
- Troubleshooting
- Troubleshooting Unexpected Behaviors
- Two Active Servers
- Two Passive Servers
- Synchronization Failures
- Registry Status is Out of Sync
- Channel Drops
- Subnet or Routing Issues
- MaxDiskUsage Errors
- MaxDiskUsage Error Messages
- [L9]Exceeded the Maximum Disk Usage (VCChannelExceededMaxDiskUsageException)
- [L9]Exceeded the Maximum Disk Usage on the ACTIVE Server
- [L9]Exceeded the Maximum Disk Usage on the PASSIVE Server
- [L20]Out of Disk Space (VCChannelOutOfDiskSpaceException)
- Application Slowdown
- Poor Application Performance
- Both Servers Can Accommodate the Initial Load but the Load Has Increased
- One Server Can Provide Adequate Resource Support, but the Other Cannot
- Scheduled Resource Intensive Tasks
- Glossary
VMware, Inc. 43
Chapter 5 Application Protection
Change the Order of Services
The order of services can be modified using Up and Down arrows. The exact order in which services start and
stop is influenced by a number of key factors:
The order of applications specified by plug-ins determines which services are started first.
Services can have dependencies, and these must be respected. For example, if service B is listed after
service A under the User-Defined group, and service A depends on Service B, Service B starts first.
Multiple applications can use the same service (the same service can appear under more than one
sponsor). The service starts when the first application to reference it starts.
The order of stopping services is the reverse for starting services.
Removing a Service
To remove a service
1 Select the service in the Applications: Services page.
2Click Remove.
The service is removed from the protected list.