6.4
Table Of Contents
- Administrator Guide
- Contents
- About This Book
- Getting Started
- Introduction
- Configuring vCenter Server Heartbeat
- System Administration and Management
- Server Protection
- Network Protection
- Application Protection
- Application Protection Overview
- Applications: Applications Tab
- Reset the Application Health Status
- View Application Status
- Setting the Application Timeout Exception
- Remove an Application
- Manually Start and Stop Applications
- Configuring Applications
- Application Maintenance Mode
- Reviewing the State of an Application
- Reviewing the Applications Log
- Filtering Application Log Entries
- Applications: Services Tab
- Applications: Tasks Tab
- Applications: Plug-ins Tab
- Status and Control
- vCenter Server Heartbeat Console
- About vCenter Server Heartbeat Console
- Work with Groups and Pairs
- Add, Edit, Move, and Remove Pairs in VCenter Server Heartbeat Groups
- Review the Status of vCenter Server Heartbeat Groups and Pairs
- Exit vCenter Server Heartbeat Console
- Shut Down Windows Without Stopping vCenter Server Heartbeat
- Controlled Shutdown
- vSphere Client Plug-in
- Uninstall vCenter Server Heartbeat
- Performance Protection
- Data Protection
- Alerts and Events
- Troubleshooting
- Troubleshooting Unexpected Behaviors
- Two Active Servers
- Two Passive Servers
- Synchronization Failures
- Registry Status is Out of Sync
- Channel Drops
- Subnet or Routing Issues
- MaxDiskUsage Errors
- MaxDiskUsage Error Messages
- [L9]Exceeded the Maximum Disk Usage (VCChannelExceededMaxDiskUsageException)
- [L9]Exceeded the Maximum Disk Usage on the ACTIVE Server
- [L9]Exceeded the Maximum Disk Usage on the PASSIVE Server
- [L20]Out of Disk Space (VCChannelOutOfDiskSpaceException)
- Application Slowdown
- Poor Application Performance
- Both Servers Can Accommodate the Initial Load but the Load Has Increased
- One Server Can Provide Adequate Resource Support, but the Other Cannot
- Scheduled Resource Intensive Tasks
- Glossary
Installation Guide
18 VMware, Inc.
3 Start intercepting updates to protected data. Any updates to the protected data are saved in the send
queue on the local server.
4 Start all protected applications. The applications use the replicated application data to recover, and then
accept re-connections from any clients. Any updates that the applications make to the protected data are
intercepted and logged.
At this point, the originally active server is offline and the originally passive server is filling the active role
and running the protected applications. Any updates that completed before the failover are retained.
Application clients can reconnect to the application and continue running as before.
Managed Failover
Managed failover is similar to automatic failover in that the passive server automatically determines that the
active server has failed and can warn the system administrator about the failure; but no failover actually occurs
until the system administrator manually triggers this operation.
Automatic Switchover and Failover in a WAN Environment
Automatic switchover and failover in a WAN environment differ from an automatic switchover and failover
in a LAN environment due to the nature of the WAN connection. In a WAN environment, automatic
switchover and failover are disabled by default in the event that the WAN connection is lost.
Should a condition arise that would normally trigger an automatic switchover or failover, the administrator
will receive vCenter Server Heartbeat alerts. The administrator must manually click the Make Active button
on the Server: Summary page of the vCenter Server Heartbeat Console or vSphere Client to allow the roles of
the servers to switch over the WAN.