Installation guide

Installation Guide
40 VMware, Inc.
13 Click Open Network Connections to change the static IP address of the Principal (Public) adapter to
match that of the Primary server (LAN configuration only).
14 If in a WAN environment, verify the Secondary Principal (Public) adapter IP address configuration.
Click Next and go to Step 16.
15 When the Secondary server is virtual, although you previously configured the IP address of the Principal
(Public) network connections, you can make any last minute changes on the Secondary server through
vCenter Server Heartbeat. Click Next and go to Step 29.
16 The Microsoft Windows Backup Restore page shows the process of unbinding the vCenter Server
Heartbeat Packet Filter and disabling NetBIOS from the VMware Channel NIC(s). A caution message
appears, advising you that the restore process is initiating and upon completion, the server must be
restarted. After restarting, Plug-and-Play (PnP) can require you to restart the machine again. Click Next.
17 The NTBackup wizard launches. If NTBackup has never run before, the software searches for backup
devices. Close any open wizards and click Restore Wizard on the Welcome page.
18 Click Next in the Restore Wizard. Click Browse to locate the previously generated backup file.
19 Navigate to the partition and select the folder in which the backup file was created, select the backup file,
click Open and then click OK.