5.0

Using Converter Standalone with Virtual Machine Sources and System
Images
With Converter Standalone, you can convert virtual machines and system images, and configure VMware
virtual machines.
Converting virtual
machines
You can convert VMware virtual machines from and to Workstation,
VMware Player, VMware ACE, VMware Fusion, ESX, ESXi Embedded,
ESXi Installable, and VMware Server. You can also import virtual machines
from Microsoft Virtual Server and Virtual PC.
To be able to run an imported VMware virtual machine and its source virtual
machine on the same network, you must modify the network name and IP
address on one of the virtual machines. Modifying the network name and IP
address allows the original and new virtual machines to coexist on the same
network.
Configuring virtual
machines
If the VMware virtual machines have disks that are populated by using a
backup of a physical host or by cold cloning, Converter Standalone prepares
the image to run on VMware virtual hardware. If you have used a third-party
virtualization software to create a virtual machine on an ESX host, you can use
Converter Standalone to reconfigure it. You can also reconfigure any operating
system installed on a multiboot machine if you have imported the virtual
machine to an ESX host. Before you reconfigure a multiboot machine, you must
change the boot.ini file.
System Settings Affected by Conversion
A VMware virtual machine that Converter Standalone creates contains a copy of the disk state of the source
physical machine, virtual machine, or system image. Some hardware-dependent drivers and sometimes the
mapped drive letters might not be preserved.
The following source computer settings remain unchanged:
n
Operating system configuration (computer name, security ID, user accounts, profiles, preferences, and so
on)
n
Applications and data files
n
Volume serial number for each disk partition
Because the target and the source virtual machines or system images have the same identities (name, SID, and
so on), running them on the same network might result in conflicts. To redeploy the source virtual machine or
system image, make sure that you do not run the source and target images or virtual machines on the same
network at the same time.
For example, if you use Converter Standalone to test whether you can run a Virtual PC virtual machine as a
VMware virtual machine without first decommissioning the original Virtual PC machine, you must first resolve
the duplicate ID problem. You can resolve this problem by customizing the virtual machines in the
Conversion or the Configuration wizard.
VMware vCenter Converter Standalone User's Guide
16 VMware, Inc.