Installation guide

In addition to the above events, the HW Predictive event (see Subsection 1.6.8) is provided.
▪ The HW Predictive event is disabled in Standard Policy (VM Server) and Standard Policy (VM Server Power
save).
▪ The HW Predictive event is enabled in Standard Policy (VM Server Predictive). (Recovery actions are
disabled.)
*1 This is a monitoring setting for events of machine down and startup of a virtual machine
server available with working together with vCenter Server. You can select the operation
mode of configuring to switch machine down and startup machine available with working
together with NEC ESMPRO Manager and restoration process.
If you use ESX 5.0, work with it by switching to "machine down" or "startup machine" in the
Recovery Action so that vCenter Server can monitor events.
*2 Disabled in Standard Policy (VM Server) and Standard Policy (VM Server Predictive).
Enabled in Standard Policy (VM Server Power save).
*3
You can set the Suppress Machine inaccessible error towards the VMS Access Impossible
event and the Target Access Impossible event.
The Suppress CPU Load failure is not set.
For instructions on how to set the suppression on an event, see Subsection 4.10.5,
"Configuring Policy Property Settings" in SigmaSystemCenter Configuration Guide.
1.6.5. Standard Policy (VM Server ESXi)
The following table shows the settings of a Standard Policy (VM Server ESXi).
Event Name
(Default)
Report Source Event Event Handler
Settings
Name
(Default)
Recovery
Action
Event
State
VMS
connection
state is green
StandaloneEsxProvider Alarm Host
connection state on
VMS changed from
red to green
Set Ready
Status
Notification/
E-mail, Event
Log
Enable
Machine status /
Set ready status
VMS
connection
state is red
StandaloneEsxProvider Alarm Host
connection state on
VMS changed from
green to red
Move all VMs
on the VM
server
Notification/
E-mail, Event
Log
Enable
Machine status /
Set faulted
status
Action for
machine/
Diagnose and
Power OFF
Action for VMS /
Move all VMs
on the VM
server.
(Failover)
Target Down AliveMonitor No response from the
machine.
Move all VMs
on the VM
server
Notification/
E-mail, Event
Log
Disable