Installation guide

NO. Action Sequence Names
Corresponding machine
configuration change
Functions Physical
Machine
Virtual
Machine
25 PowerCycleMachine
Power Operation to machine /
Power Cycle
Powers off and then Power on a running
machine.
A *4 N
26 AcpiShutdownMachine
Power Operation to machine / ACPI
Shutdown
Executes ACPI shutdown on a running
machine.
A *4,5 N
27 DumpMachine
Dump Machine
Sends dump demand to a machine. A *4,5 N
28 LedTurnOnMachine Sends LED on demand to a running
machine.
A *4 N
29 LedTurnOffMachine Sends LED off demand to a running
machine.
A *4 N
30 ApplyOptimizedPlacementRule Applies the Optimized Placement Rule. N A
31 CreateImage Creates an image. N A
32 CreateTemplate Creates a template. N A
33 InvestigateAndPowerOff Diagnoses a machine. A A
34 InvestigateMachineAndSetFaulted Diagnoses the specified type machine. A A
35 InvestigateMachineAndSetReady Executes total recover diagnosis and sets
ready status.
A A
36 ModifyRunningMachine Modifies a running machine. A A
37 PowerSaveVMserver Executes power save of a VM server. A N
38 PredictiveShutdownVMServer Stops a VM server (Predictive). A N
39 PredictiveStartupVMServer Starts up a spare VM server. A N
40 ReconstructVirtualMachine Reconstructs a virtual machine. N A
41 ScaleIn Executes ScaleIn. A A
42 ScaleOut Executes ScaleOut. A A
43 ShutdownAtScaleIn Shuts down a machine according to the
group setting.
A A
44 StartupAtScaleOut Starts up a machine according to the group
setting.
A A
45 SuspendAtScaleIn Suspends a machine according to the group
setting.
N A
*1 This operation is executed only when the target is a physical machine.
*2 If the target is a virtual machine, customizing the machine is executed. If the target is a physical
machine, it depends on the type of distribution software.
*3 This operation is executed only when the target is a virtual machine.
*4 Out-of-Band Management must be enabled.
*5 OS on a target machine must be configured appropriately.
A: action sequence applicable
N: action sequence not applicable